SLV 1006541 48V Track Surface Instruction Manual
- June 15, 2024
- SLV
Table of Contents
**SLV 1006541 48V Track Surface
**
Package Content
The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
Installations
Dimension
Read manual carefully and keep for further use!
Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
The components and luminaires of this system may not be combined with track
systems of safety class I or II or with any other track system.
The track ends must be covered with end caps suitable for the system.
Do not fasten anything on the product.
Do not cover the product.
Take out of service when suspecting a defect or malfunction and contact your
dealer or a qualified electrician.
Take measures that children get not harmed by the product.
Additional safety advices =
Use as directed
Electrical Track System for lighting
Safety class III (3) – Operated with safety extra-low voltage.
Operate only in dry indoor area.
Do not strain mechanically or expose to strong dirt contamination.
Operation
It is the responsibility of the user to ensure the electrical and thermal
compatibility between the rail system and the luminaires connected to it.
Caution: To avoid the danger of overheating and fire the conductors may
not be bridged.
The electrical screw connections have to be checked regularly on the voltage-
free track and if necessary be tightened hand-screwed.
Do not direct luminaires on the track, other luminaires or the transformer.
Care / Storage
Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Store dry and clean.
Installation
Switch off mains / fixed connection cable!
Use only described accessories.
Suited for horizontal and vertical wall installation and ceiling installation.
Note the load limit.
The specified admissible mechanical load of the tracks is the total load of a
complete system.
Install as shown in the figure.
Prepare power supply.
The feed-in may only be connected to a SELV supply which is specified to
operate components of the safety class III.
The electrical connection with screws on feed-ins have to be tightened
securely.
All open rail ends must be equipped with end caps.
Check secure fixation and proper function!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>