SLV 1005441 Outdoor Floor Stand Luminaire Instruction Manual
- May 15, 2024
- SLV
Table of Contents
SLV 1005441 Outdoor Floor Stand Luminaire
SYMBOLS
100V-277V~50/60Hz| 15W| 3000K: 1240 lm 4000K: 1300 lm| CRI>80| 30 x 7
x 113 cm| 4,40 kg
---|---|---|---|---|---
HARDWARE LIST
PARTS A Floor lamp
INSTALLATION INSTRUCTIONS
The installation requires expert knowledge and may be carried out only by an
approved electrician under consideration of local and national regulations!
The light source is only exchangeable by a professional. The separate control unit is only exchangeable by a professional.
Technical Details are subject to change
SLV UK Unit E Chiltern Park Boscombe Road, Bedfordshire LU5 4LT
Operating Manual PART B Outdoor Floor Stand Luminaire
Read manual carefully and keep for further use!
Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Operate only with intact protection glass.
The supply cord may not be covered with soil.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or a qualified electrician to
avoid hazard.
Take out of service when suspecting a defect or malfunction and contact your
dealer or a qualified electrician.
Take measures that children get not harmed by the product. Do not stare into
the active light source.
Additional safety advices =
Use as directed
Safety class I (1) – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only on normal or not inflammable surfaces.
Do not strain mechanically or expose to strong dirt contamination.
IP65: Protection against dust (dust-tight) – Protection against jetted water
from all directions.
Admissible ambient temperature(ta): -20°C …+40°C.
Light Source
The light source of this luminaire may only be replaced by the manufacturer,
an authorized service technician or a comparable qualified person.
This product contains a light source of the energy efficiency class E.
Reference control setting: 4000K
Care / Storage
Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Do not clean with pressure washer.
The base may not be covered (e.g. with foliage, soil, etc.)
Openings providing aeration or drainage must be kept free.
The following influences may have unwanted effects on the product: acidic
surrounding, high salt content in the air, cleaning agents, fertilizer,
thawing salt, chemicals.
Store dry and clean.
Installation
Switch off mains / fixed connection cable!
Use only described accessories.
Use only suitable fastening materials.
Only suited for ground surface mounting.
Follow local regulations for outdoor installations.
Do not seal the product yourself (e.g. with silicone).
Install according to declared IP type. Install as shown in the figure.
Electrical connection
Equip flexible wire ends with suitable wire ferrules!
Live conductor → Terminal L
Neutral conductor → Terminal N
Protective conductor → Earth terminal
Check secure fixation and proper function!