ROADSAFE TSS001 Transmission Spacer Kit Instructions
- June 13, 2024
- ROADSAFE
Table of Contents
ROADSAFE TSS001 Transmission Spacer Kit
VEHICLE Mazda BT50 & Ford Ranger Gen 2 11/11 – onwards
- PRODUCT Transmission Spacer Kit
- ART NUMBER TSS001
TOOLS REQUIRED
- 19mm socket
- Ratchet
FITTED TO PX RANGER 2012 – ONWARD
A maximum of a 24mm spacer is available in 4mm increments
- This product can be fitted with the vehicle on the ground. If raising the vehicle, ensure the vehicle is correctly supported. Support the driveshaft in the case it may fall and cause injury. Follow the instructions below for both sides of the bearing.
- Ensuring the mount is supported, remove both retaining nuts from the center bearing carrier.
- Place the desired amount of spacers over the stud, with the balance of spacers not being used placed under the head of the new bolt supplied.
- Install bolt with split washer placed under the bolt head, tighten with 19mm socket—Do not over-tighten.
- Test drive the vehicle and assess vibration. If all spacers are fitted and the vibration is still evident, you may require a Pinion angle adjustment using our WEDGE plates and SB022—long head leaf spring center bolt.
HARDWARE SUPPLIED
- 2 x female bolts
- 12 x 4mm spacer washers
- 2 x split washers
BOLT TORQUE SPECS
A division of Specialist Wholesalers Pty. Ltd.
ABN 64 163 280 279 roadsafe.com.au VIC PH: 03 8687
1700
QLD PH: 07 3737 7420 | Email:
sales@roadsafe.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>