SLV 1006452 Trailing Edge Dimmer Instruction Manual

June 12, 2024
SLV

INSTRUCTION MANUAL PART A
Trailing Edge Dimmer with DALI Control Input and
Push-Function for LED Lighting
1006452

1006452 Trailing Edge Dimmer

Uin 100-240V AC Uout 100-240V AC Iout 1,8A max.
DALI (in) 2mA max. 4,5 x 4,5 x 2 cm

The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
SLV UK Unit E Chiltern Park I Boscombe Road, Bedfordshire LU5 4LT

SLV 1006452 Trailing Edge Dimmer - Fig1

Operating Manual PART B
Trailing Edge Dimmer with DALI Control Input and Push-Function for LED Lighting 1006452
Read manual carefully and keep for further use!
 Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not open the housing, it protects against touching active parts.
The load of the connected LED lighting may not exceed the maximum load of the device.
Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
Additional safety advices =

Furnishing

Built-in DALI 2 Interface, DALI DT6 Device
Use as directed
This product is suited to control the brightness of LED lighting with an input power of 100 – 240V AC.
Safety class II (2) Icon – Safety insulated – Connection without protective conductor.
Do not strain mechanically or expose to strong dirt contamination.
Admissible ambient temperature(ta): -20°C …+50°C.
Admissible load types

Symbol Load Type Max. Load
Dimmable
LED Lamp 230V: 200W

120V: 100W
| Dimmable
LED Driver| 230V: 200W
120V: 100W

Installation

Switch off mains / fixed connection cable!
The device is suitable for installation in a standard flush-mounted box (Ø:
60mm / min. depth 45 mm).
Access to the built-in product must only be possible via a tool.

Electrical connection

See connection diagrams.
Connection to DALI Fig. A
Connection to a Push-button Fig. B
Equip flexible wire ends with suitable wire ferrules!
Live conductor → Terminal L
Neutral conductor → Terminal N

Operation

DALI
Please read the instruction of the DALI master device to setup the DALI address.
Push-button Operation
A short push switches the light on and off.
A short push changes the brightness.

Settings

Setting and deleting the minimum brightness
Adjust the desired minimum brightness via DALI or push-function.
Push the button “Min. Set” on the device until the LED on the device starts to flash.
To delete the minimum brightness, adjust the brightness to the highest level and push the button “Min. Set”. The flashing LED on the device indicates that the minimum brightness was deleted.
Notice: The dimming range ranges from 1 – 100%. With some load types it may appear that the connected light flashes at a dimming level of 1%. In such cases it is recommended to set the minimum brightness above 1%.

© 22.11.2022 SLV GmbH, Daimlerstr. 21-23, 52531
Übach-Palenberg, Germany,
Tel. +49 (0)2451 4833-0.
Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals