Ford M-1447-BLBR, BLMB, BEBR 2021 +MY Bronco Bronco Overlay Kits Instruction Manual

Ford M-1447-BLBR, BLMB, BEBR 2021 +MY Bronco Bronco Overlay Kits

Product Information

• Product Name: M-1447-BLBR, BLMB, BEBR 2021+MY Bronco Bronco Overlay Kits
• Manufacturer: Ford
• Shop Manual Purchase Options: www.motorcraftservice.com
• Techline: 1-800-367-3788

Product Usage Instructions

1. Installation:
2. Prepare surface by thoroughly cleaning all the installation surfaces using an isopropyl alcohol mixture and a clean lint-free cloth. Allow the surface to dry thoroughly. Note that the emblem cap and vehicle surfaces must be between 70°F and 110°F at the time of installation. A heat source may be used to reach the minimum temperature if necessary.
3. Before removing the adhesive, check the fitment of the overlays on the factory parts. Make sure to check the orientation of the overlays. The first “O” has one notch on the bottom, the “N” has one notch on the bottom, and the last “O” has two notches on the bottom.
4. Using the pull tab(s), gently pull to remove the adhesive liner from the backside of the overlay. Do not touch the adhesive liner during installation.
5. Position the overlays over the factory part starting from the top edge then downward, ensuring it is centered properly. Press lightly to adhere.
6. Using a lint-free scratch-resistant cloth, press firmly on the overlays from the center working outwards to the edges to ensure maximum adhesion contact.

NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF FORD PERFORMANCE PARTS © Ford Motor Company 2020

Special Tool(s) / General Equipment

Installation

1. Prepare surface by thoroughly cleaning all the installation surfaces using an isopropyl alcohol mixture and a clean lint free cloth. Allow the surface to dry thoroughly.
   NOTE: Emblem cap and vehicle surfaces must be between 70 ⁰F and 110 ⁰F at time of installation. A heat source may be used to reach minimum temperature if necessary.
   

2. Before removing the adhesive, check fitment of the overlays on the factory parts.
   NOTE: Check orientation of the overlays. The first “O” has one notch on the bottom, the “N” has one notch on the bottom, and the last “O” has two notches on the bottom.
   

3. Using the pull tab(s), pull gently to remove the adhesive liner from the backside of the overlay.
   NOTE: Do not touch the adhesive liner during installation.

4. Position the overlays over the factory part starting from the top edge then downward, ensuring it is centered properly. Press lightly to adhere

5. Using a lint-free scratch resistant cloth, press firmly on the overlays from the center working outwards to the edges to ensure maximum adhesion contact.

iPRIOR TO INSTALLATION READ THESE INSTRUCTION COMPETELV

• For questions, Call the FORD PERFORMANCE Techline l-800-367-3788
• Please visit https://www.performanceparts.ford.com for warranty information

Ford Factory Shop Manual purchase options www.motorcraftservice.com
Techline 1-800-367-3788
IS M-1447-XXXX 031523

References

• Official Site of Ford Performance Parts - Mustang Parts, Crate Engines, Packs, Wheels, Superchargers, Racing Parts | Performance Parts Authority

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>