BEGA 44769 Ceiling Wall Pillar Luminaire Instruction Manual

: June 12, 2024
: BEGA

Table of Contents

Dimension
Instructions for use
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BEGA 44769 Ceiling Wall Pillar Luminaire Instruction Manual

Dimension

Instructions for use

Application

Unshielded luminaire for installation under ceilings, on walls as well as on pillars and murals.
By means of the three-ply opal glass the light is distributed softly and uniformly over the glass surface.

Product description

Luminaire made of aluminium alloy and stainless steel
BEGA Unidure® coating technology
Opal glass with screw neck 2 mounting holes ø 6mm
Distance apart 65mm 2 cable entries for through-wiring of mains supply cable ø 7-10.5mm
Connection terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 65
Dust-tight and protection against water jets Impact strength IK02
Protection against mechanical impacts < 0.2 joule
– Safety mark
– Conformity mark
Weight: 2.8 kg

Safety

The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Lamp

Luminaire with screw base E 27
Lamp output max. 100 W
This product contains light source of energy efficiency class E

Supplied lamp
BEGA LED lamp 13590
LED Retrofit 12 W · 1400 lm · 3000 K

Luminaire efficiency: 86%

Additional BEGA LED lamps are available for this luminaire:

13 584 LED 7 W · 805 lm · 3000 K
13 586 LED 7 W · 805 lm · 3000 K dimmable
13 588 LED 8 W · 1055 lm · 3000 K
13 592 LED 12 W · 1400 lm · 3000 K dimmable

Radio-controlled version (Zigbee 3.0):

13 555 LED 9 W · 805 lm · 2700 K dimmable
13 556 LED 9 W · 805 lm · 2700-6500 K dimmable · tunable white
13 557 LED 9.5 W · 805 lm · 2700-6500 K dimmable · tunable white · RGBW

Detailed technical and lighting data for the lamps can be found in the data sheets on our website.

Installation

Undo screws on circular blank of lampholder.
Remove circular blank of lampholder from luminaire base.
Lead the mains supply cable through the cable entry into the luminaire housing.
In case of installation on a foundation, please observe the following: Wet concrete can be highly alkaline and must not come into contact with the luminaire permanently.
We recommend draining the installation area and painting it with insulating paint.
Fix luminaire base with enclosed or any other suitable fixing material onto the mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Assemble circular blank of lampholder in luminaire base. Insert lamp.
Screw glass with gasket firmly into the luminaire base.
Make sure that gasket is positioned correctly.

Relamping · Maintenance

Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary.
Close the luminaire.
For cleaning, do not use high pressure cleaners.