BEGA 12194.2 Large Area Ceiling Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 12194.2 Large Area Ceiling Luminaire Instruction Manual
Application
Large-area ceiling luminaire · indoor luminaire with optical system aluminium housing. With direct and indirect light, for glare-free lighting in the workplace.
Product description
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping.
Please note :
It is recommended to deploy 2 people to install this luminaire. Unpack
mounting plate with canopy. Pull off canopy from mounting plate against the
magnetic resistance. Strip cable end approx. 80 mm. Lead mains supply cable
through the elongated hole of the mounting plate. Fix mounting plate with
enclosed or any other suitable fixing material onto the mounting surface. Make
earth connection and electrical connection to to the terminals of the power
supply unit. For digital control please use the connecting terminal DA, DA. In
case this terminal is not used the luminaire will be operated at full light
output.
Unpack luminaire.
Detach the matt black trim strip unilaterally from each of the short sides of
the luminaire beyond the corner of the profile. Take up the luminaire and
slide in the cleared profile grooves on both sides of the hangers for about 70
– 100 mm so that the luminaire terminals are within reach. For that purpose it
is necessary to push the clamping pieces upwards by means of the bottom-side
screws, see sketch. Make sure that the luminaire cable is not damaged during
insertion.
Lead the luminaire cable through the enclosed membrane grommet and make LEDconnection to the terminals. Pay attention to correct polarity, black: “Driver -“, red: Driver +”. Place canopy on top of the luminaire housing. Make earth connection (plug connection ) between canopy and mounting plate. Push the membrane grommet into the provided opening and attach canopy onto the mounting plate by means of the magnets.
Slide in luminaire evenly until the mid position of the hangers. Make sure to push both bottomside screws at the same time. Secure position of luminaire by fixing the screws of the clamping pieces. Push in the matt black trim strip into the profile notches on both of the short sides of the luminaire. To conceal the groove push the end section of the trim strips under the hangers. Push excessive cable through the membrane grommet into the canopy.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt. To clean the optical system of the luminaire an antistatic cleaner for synthetic materials is recommended. Note care instructions accordingly.
Spares
LED power supply unit DEV-0214/1050
LED module 3000 K LED-0619/930
LED module 4000 K LED-0619/940
LED module 3000 K LED-0618/930
LED module 4000 K LED-0618/940
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>