BEGA 51206.5 NEUE LEUCHTE System Pendant Luminaire Instruction Manual

June 12, 2024
BEGA

BEGA logo 51206.5 NEUE LEUCHTE System Pendant Luminaire
Instruction Manual NEUE LEUCHTE
**** 51 206.5

 51206.5 NEUE LEUCHTE System Pendant Luminaire

Technical amendments reserved
System pendant luminaire for indoor useBEGA 51206.5 NEUE LEUCHTE System
Pendant Luminaire - FIG

Instructions for use

Application
Ceiling luminaire downlight · indoor luminaire with broad spread light distribution.
BEGA Hybrid Optics® : Highly efficient and lowloss light distribution, thanks to reflector and optical lens.
BEGA System pendant luminaire for use in combination with various modular BEGA installation components.

Product description

Pendant luminaire downlight
Die-cast aluminium luminaire housing, velvet black,
Reflector surface made of pure aluminium
Optical silicone lens · BEGA Hybrid Optics ®
Trim ring · Chrome finish
Clear safety glass
Black flex suspension 2 x 0,75@
Overall length of luminaire approx. 1500 mm
Safety class III

** – Conformity mark
Weight: 1.5 kg
This product contains light sources of energy efficiency class(es) D
Luminaire without canopy, for connection to an additional required
BEGA Installation component (accessory)
Lamp**

Module connected wattage 16.8 W
Luminaire connected wattage 19.8 W
Rated temperature ta = 25 °C
Ambient temperature ta max = 35 °C

51 206.5 K3

Module designation LED-0978/930
Colour temperature 3000 K
Colour rendering index CRI > 90
Module luminous flux 2440 lm
Luminaire luminous flux 1999 lm
Luminaire luminous efficiency 101 lm / W

Lighting technology
Half beam angle 61°

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Please note:
The luminaire can only be operated with an operating device that fulfills the requirements according to EN 61347-2-13.
The maximum idle voltage of 60 V DC must conform to SELV or SELV equivalent.

Installation

LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping.
Screw enclosed trim ring with attached reflector into the luminaire housing by turning it clockwise.
To operate this luminaire one of the following additional BEGA Installation components must be ordered – accessoire.
Please refer to the instructions for use for the BEGA installation component selected for luminaire installation
Please note:
The manufacturer accepts no liability for damage caused by improper use or installation if no BEGA installation component is used to install this BEGA system pendant luminaire.

Cleaning · Maintenance

Clean luminaire regularly with solvent-free cleansers from dirt.

Replacing the LED module

The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified person using commercially available tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Close the luminaire.

Accessories

BEGA Installation components with LED power supply unit.
Satin black finish
Depending on the desired type of installation, the following suitable installation components are available for this BEGA system pendant luminaire:
For all level ceilings:

13 237 Surface-mounted canopy (Type A) DALI · 220-240 V · 490 mA DC
13 265 Surface-mounted canopy (Type AS) Smart controllable / dimmable·

220-240 V · 490 mA DC

Suitable for level ceilings and sloped ceilings with a pitch of 0 – 40°:

13 243 Surface-mounted canopy (Type B) DALI · 220-240 V · 490 mA DC
13 249 Recessed canopy (Type C) DALI · 220-240 V · 500 mA DC
13 271 Recessed canopy (Type CS) Smart controllable / dimmable · 220-240 V ·

500 mA DC

For flush and surface-mounted 3-phase Eurostandard-Plus ®track systems:

13 219 Stromschienenadapter (Typ D) DALI · 220-240 V · 500 mA DC

For the accessories a separate instructions for use can be provided upon request.
Spares

Glass/Trim ring 20 000 042 B4
LED module 3000 K LED-0978/930
Reflector unit 75 004 687

BEGA logoBEGA Gantenbrink-Leuchten KG
Postfach 31 60
58689 Menden
info@bega.com 
www.bega.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals