Ford 132 Super Duty F-Series Upfitter Interface Module Instruction Manual
- June 9, 2024
- Ford
Table of Contents
Ford 132 Super Duty F-Series Upfitter Interface Module
UPFITTER INTERFACE MODULE (UIM)
The UPFITTER INTERFACE MODULE (UIM) is an electronic control module that provides read-access to numerous vehicle CAN messages, as well as up to 10 upfitter-wired signal inputs, for the purpose of programming output signals to control aftermarket equipment (such as lift buckets, cranes, motors, salt spreaders, snow plows, etc.). Program ming software and usage manuals are available at https://www.fleet.ford.com/partsandservice/upfitter-interface/.
For more detailed info on the UIM, refer to the General Body Builders Layout Book available at www.fordbbas.com/publications.
The UIM Gen1 is available on all Super-Duty Chassis Cabs and Pickups MY2017 and newer(Order Code 18A), and is located under the kick-panel trim in the front passenger (RH) footwell. If your MY2017+ Super-Duty was not originally built with the UIM option, it can easily be retrofitted by ordering and installing the UIM module and its harness. The Module and the Harness must both be ordered for retrofits. See part numbers below.
Service Part Number: HC3Z-14G372-B Upfitter Interface Module (GEN1)
Service Part Number: LC3Z-14A303-B UIM Harness
NOTE : Check with Ford Dealer for latest part levels.
UIM Location (Super-Duty)
CHASSIS CAB UPFITTER RELAY BOX
The Upfitter Relay Box, located underhood on the passenger side, contains relays that are controlled by the Upfitter Switches in the cab overhead console. See the separate section of this BBLB for more info on the Upfitter Switches. There are six blunt-cut wires, correlating to the 6 Upfitter Switches, extending out from the bottom of the Upfitter Relay Box, which upfitters may use to route switch signals to their installed equipment as desired.
Six Upfitter Switch Blunt-cuts (located underhood below Upfitter Relay
Box):
In addition to the 6 Upfitter Switch blunt-cut wires described above, this harness bundle also contains 4 customer-access blunt-cut circuits. See table below.
Engine Bay- Passenger Side
illustration
Four Customer-Access Blunt-cuts !located underhood below Uofitter Relav
Boxl:
Either F4A or F4C can be installed but not both at the same time. Upfitter Relay Box is shipped with fuse in F4A position See schematic on a subsequert page of ttis BBLB.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>