SLV 147361 Wall and Ceiling Light Instruction Manual

147361 Wall and Ceiling Light

Product Information

This wall and ceiling light fixture is available in three models (147360…61, 147370…71, and 147380…81) and comes with an instruction manual (Parts A and B). The fixture weighs between 0.27 kg and 1.25 kg, depending on the model. It operates at 220V-240V ~50/60Hz and requires QPAR51 or GU10 light bulbs with a maximum wattage of 50W. The dimensions of the fixture range between 8.6 x 5.6 x 8.6 cm and 56 x 5.6 x 8.6 cm.

Product Usage Instructions

Before installing or using the fixture, read the instruction manual carefully and keep it for future reference. The installation and electrical connection should be carried out only by a qualified electrician in accordance with local and national regulations.

INSTRUCTION MANUAL PART A Wall- and Ceiling Light

Installation

1. Switch off the mains/fixed connection cable before installingthe fixture.
2. Use only the described accessories and suitable fastening materials.
3. Only mount the fixture on a wall or ceiling surface.
4. Note the distance to the illuminated surface (minimum of 0.5m).
5. Install the fixture as shown in the figure.

Switch off mains / fixed connection cable! Use only described accessories.

Use only suitable fastening materials.
Only suited for wall and ceiling surface mounting. Note the distance to the illuminated surface. Install as shown in the figure.

Lamp Replacement

1. Disconnect the luminaire from mains and let it cool down before replacing the light bulb.
2. Use only suitable replacement light bulbs with a maximum wattage of 50W (QPAR51 or GU10).

Care and Maintenance

1. Disconnect the fixture from mains and let it cool down before cleaning or performing maintenance.
2. Regularly clean the external surfaces of the fixture with a slightly moistened (water) cloth.
3. Store the fixture in a dry and clean place.

Safety Recommendations

• Do not alter or modify the product, fasten anything on it, or cover it.
• Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
• Take measures to ensure children are not harmed by the product.
• Operate the fixture only on normal or non-inflammable surfaces in dry indoor areas.
• Do not strain mechanically or expose the fixture to strong dirt contamination.

Following these instructions will ensure safe and proper use of the wall and ceiling light fixture.

The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!

www.marbel.ru

SLV UK
UK Unit E Chiltern Park
CA Bascombe Road, Bedfordshire
LU5 4LT

Disposal (European Union)

Do not dispose the product with the regular household waste! Products marked with this sign must be disposed according to the directive (WEEE) on electrical and electronic devices at local collection points for such devices! Waste batteries and accumulators, which are not enclosed by the waste equipment, and lamps, which are removable non-destructively from the waste equipment are to be separated non-destructively from the waste equipment before turning to a local collection point. Distributors are, according to particular legislation, obligated to take back waste equipment from the final holder. It lies in the personal responsibility of the final holder to delete personal data before the disposal. For disposal the waste equipment may be send to the following address:

SLV GmbH
Technischer Service
Werkstrasse 8-10
52531 Übach-Palenberg, Germany

Operating Manual PART B

Wall- and Ceiling Light
147360 …61 147370 …71 147380 …81 1002029 …30

Read manual carefully and keep for further use!
Safety advices for installation and operation. Disregard may lead to danger of life, burning or fire! Any works on the electrical connection only by electrician. Do not alter or modify the product. Do not fasten anything on the product. Do not cover the product. Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician. Take measures that children get not harmed by the product.

Use as directed
Safety class I (1) – Connection with protective conductor. Operate only firmly fixed on an even surface. Operate only on normal or not inflammable surfaces. Operate only in dry indoor area. Do not strain mechanically or expose to strong dirt contamination.

Minimum distance of light source to illuminated surface: 0,5 m.
Max. admissible ambient temperature(ta): 40°C.

Lamp replacement
Disconnect luminaire from mains and let it cool down. Suitable light sources: QPAR51, GU10, 50W max.

Care / Storage
Disconnect product from mains and let it cool down. Clean external surfaces regularly with a slightly moistened (water) cloth. Store dry and clean.

Electrical connection

Equip flexible wire ends with suitable wire ferrules!

Live conductor :T erminal L
Neutral conductor : T erminal N
Protective conductor : Earth terminal

Check secure fixation and proper function!

References

• Marbel | Компания «Марбел» официальный представитель светотехнического холдинга SLV GmbH в России

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>