SLV 229324 Inground Fitting Light Instruction Manual

: June 9, 2024
: SLV

Table of Contents

SLV 229324 Inground Fitting Light
SPECIFICATION
INSTRUCTION MANUAL PART A
Operating Manual PART B
Installation
Electrical connection
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SLV 229324 Inground Fitting Light

SLV-229324-Inground-Fitting-Light

SPECIFICATION

SLV-229324-Inground-Fitting-Light-1

INCLUDE

INSTRUCTION MANUAL PART A

Inground Fitting

SLV-229324-Inground-Fitting-Light-7

SLV-229324-Inground-Fitting-Light-4

The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!

Operating Manual PART B

Inground Fitting
229320 …24

Read manual carefully and keep for further use!

Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!

Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Operate only with intact protection glass.

Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
Take measures that children get not harmed by the product.

Identifies hot surfaces of the product on the product itself or on the figure.
Additional safety advices =

Use as directed
Safety class I (1) – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only on normal or not inflammable surfaces.
Do not strain mechanically or expose to strong dirt contamination.
Minimum distance of light source to illuminated surface: 0,5 m.
IP67: Protection against dust (dust-tight) – Protection against the penetration of water when temporarily submerged.

Lamp replacement
Disconnect luminaire from mains and let it cool down.
Suitable light sources: QPAR51, GU10, 35W max.
Clean gasket when dirty.
Tighten screws evenly and cross-wise.

Care / Storage
Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Note supplied cleaning instructions.
Do not clean with pressure washer.
Remove foliage, dirt, etc. regularly from the luminaire.
The following influences may have unwanted effects on the product: acidic surrounding, high salt content in the air, cleaning agents, fertilizer, thawing salt, chemicals.
Store dry and clean.

Installation

Switch off mains / fixed connection cable!
Use only described accessories.
Only suited for recessed ground installation.
Note the distance to the illuminated surface.
Follow local regulations for outdoor installations.
Do not seal the product yourself (e.g. with silicone).
Install according to declared IP type.
Install only when the weather is dry.
Provide a drainage with a minmum depth of 20 cm at the installation place.
Install as shown in the figure.
Direct the underground cable with sufficient length through the cable gland.
Secure cable gland applying a suitable tool.