SLV 1002904 Wall- and Ceiling Light Instruction Manual

June 9, 2024
SLV

SLV 1002904 Wall- and Ceiling Light

Parts

Parts

Installation Instructions

NSTRUCTION MANUAL PART A Wall- and Ceiling Light

Feature

Installation Instructions
Installation Instructions

The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!

The light source is only exchangeable by a professional. The separate control unit is only exchangeable by a professional.
Symbols

Тел факс +7812-644-6789 ./
www.marbel.ru

SLV UK
Unit E Chiltern Park
Boscombe Road, Bedfordshire LUS 4LT

Read manual carefully and keep for further use!

Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Operate only with intact protection glass or protection cover.
Take out of service when suspecting a defect or malfunction and contact your dealer or a qualified electrician.
Take measures that children get not harmed by the product.
Do not stare into the active light source
Additional safety advices = ****

Use as directed

Safety class I (1) – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only on normal or not inflammable surfaces.
Do not strain mechanically or expose to strong dirt contamination.
IP54: Protection against disturbing dust deposition – Protection against splashing water from all directions.

Light Source

The light source of this luminaire may only be replaced by the manufacturer, an authorized service technician or a comparable qualified person.
This product contains a light source of the energy efficiency class E. Reference control setting: 4000K

Care / Storage

**** Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Do not clean with pressure washer.
Openings providing aeration or drainage must be kept free.
The following influences may have unwanted effects on the product: acidic surrounding, high salt content in the air, cleaning agents, fertilizer, thawing salt, chemicals. Store dry and clean.

Installation

Switch off mains / fixed connection cable!
Use only described accessories.
Use only suitable fastening materials.
Only suited for wall and ceiling surface mounting.
Follow local regulations for outdoor installations.
Do not seal the product yourself (e.g. with silicone).
Install according to declared IP type.
Install as shown in the figure.
Tighten screws evenly and cross-wise.
Suitable Dimmer: Trailing-edge phase dimmer (Code C). Note manufacturers instructions.

Electrical connection

Direct the fixed wiring with its complete insulation at least 15 mm into the housing.
Equip flexible wire ends with suitable wire ferrules!
Live conductor Terminal L
Neutral conductor Terminal N
Protective conductor Earth terminal

**** Check secure fixation and proper function!

Detection Adjustment

The sensor is active until the surrounding light reaches the adjusted lux value.
Factory settings: 8 sec., 30 lux

Time Setting

|

Light Control

---|---
|

8 sec. à 12 min.

|

30 à 1000 lux

Customer Support

© 18.08.2022 SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany, Tel. +49 (0)2451 4833-0. Made in China.

Documents / Resources

| SLV 1002904 Wall- and Ceiling Light [pdf] Instruction Manual
1002904, Wall- and Ceiling Light, Ceiling Light, Wall Light, Light, 1002904 Ceiling Light
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals