KUPPERSBERG INNOVA V 60 Extractor Hood User Manual
- August 17, 2024
- Kuppersberg
Table of Contents
KUPPERSBERG INNOVA V 60 Extractor Hood
DEAR CUSTOMER,
Thank you for purchasing our equip-ment! We are sure that appliances of the
KUPPERSBERG brand, which are modern, functional and made of high quality
materials and components, will be a reliable assistant in your kitchen.
Please read this manual carefully before starting any installation work. It
will help you avoid premature failure, as well as extend the life of your
appliance to the maximum possible.
Please note that the installation of this appliance must be carried out by a
qualified technician and in accordance with these instructions. The manufac-
turer is not liable for any consequences of failure to observe this condition.
Caution
The manufacturer reserves the right to make any changes, without prior
notice, to design, outside appearance and scope of supply of appliance, which
will be considered as necessary and useful according to the manufacturer’s
point of view. Possible modifications will not affect the basic properties,
including those that relate to safe operation of the appliance.
SAFETY PRECAUTIONS
-
Assembling and electrical connection of the appliance must be carried out by skilled technicians of authorized service center.
-
The appliance is designed to op-erate on 220-240 V AC. Make sure that the technical parameters of your home power supply system correspond to the data for the power supply. If parameter values are above or below the specified range, the use of the appliance is prohibited.
-
Do not connect the kitchen air cleaner to the ventilation channels that are used to remove smoke and fumes from the equipment operating on any other energy sources except electric one.
-
The appliance is to be connected only to an earthed power supply system.
-
Do not cook flammable foods be-low the kitchen air cleaner.
-
Use aluminum filter that comes with the appliance. The use of other materials is prohibited!
-
Do not connect the appliance to the power supply system, until the as-sembly and installation of the appliance is completed.
-
Do not use the appliance without the aluminum filter in place.
-
Do not touch the lamps.
-
Do not remove the aluminum filter while the appliance is in operation.
-
Do not disconnect the appliance from the power supply system directly. If necessary, turn the appliance off using the control panel and, only after that, unplug it from the power supply system. When switching on: first connect the appliance to the power supply system, then switch it on using the control panel, but not vice versa!
-
The appliance requires regular cleaning and maintenance work.
-
When installing the appliance, observe the required distance between it and the cooking surface of your stove:
– for an electric stove: at least 65 cm
– for a gas or gas-electric stove: at least 70 cm -
Do not allow children to play with packaging materials, it can be dan-gerous!
-
For best air cleaning in your kitchen, do not turn off the appliance immediately after the cooking process is completed: let the appliance run for a further 15 minutes. For this purpose you can also use the timer function (the button «Auto Switch Off Timer» on the control panel).
-
Ensure adequate ventilation in the kitchen, if a gas stove is operated simultaneously with the appliance.
-
In case of any malfunctions, contact your nearest authorized service center.
-
If the kitchen hood is supposed to operate in air discharge mode, then during installation it is important to provide a duct of the corresponding diameter. To prevent loss of performance caused by aerodynamic resistance of the duct, the air duct must not be too long, or curved. Never restrict the duct size, or make sharp bends. In addition, it is preferable to use smooth PVC duct (round or flat), rather than the flexible corrugated one because bends of a corrugated duct increase the noise level of the hood.
-
The manufacturer does not bear any responsibility for any possible damage, in case of non-compliance with above precautions.
SPECIFICATIONS
Built-in hood
- Width……………………….. 526/700 mm Diameter of the air
- discharge pipe…………. 120-150 mm
- Voltage……………………. 220-240 V / 50 Hz
- Modes of operation…….. Air discharge /Recirculation
- Noise level………………….. min. 46 dB- max. 69 dB
- Lamps……………………….. LED 2×5
CONTROL TYPE
- A – On/Off switch
- B – Power speeds
- C – Turbo speed
- D– Lighting
- A – Hood motor On/Off.
- B – Power speeds (3 speeds): Press on these switches, the motor runs at LOW-HIGH speeds.
- C – When the turbo button is pressed, the turbo will run at 4th rpm for 5 minutes. It will return to speed after 5 minutes. The timer button will be activated when you hold down the revs(button B) for a long time.
- D – Lighting: Press on this switch to turn on the lights, and press again to turn them off.
Mounting and dimensions
Please unpack and inspect the appliance! Before starting installation,
make sure that the hood has no obvi-ous transport damages. If such defects are
detected, do not install or connect the appliance to the mains.
To comply with safety regulations, the distance between the cooking surface and the air cleaner should be 700 mm. For convenience of installation, each hood is provided with installation diagram. Attach the diagram to the wall, mark and drill the holes. Insert the dowels, fix the mounting hooks. Mount the hood. Repeat the same procedure for the hood chimney.
Cleaning and maintenance
Caution! Before you start cleaning the appliance, disconnect it from the power supply.
Aluminum filter
Aluminum filter is designed to trap grease particles out of the flow of air
running through it. For this reason, the filter needs regular cleaning. The
cleaning interval depends on the frequency of use of the air cleaner.
Generally, it is recommended to clean it once a month. To do this, remove the
filters, wash them in water with a neutral liquid detergent, dry them, then
set them back in the air cleaner. Over time, filters may change color due to a
regular washing. This is a natural process, which does not indicate a defect,
so filter replacement is not required.
The aluminum filters can be washed in the dishwasher.
How to remove aluminum filters
- Press on the latch of the filter lock.
- Pulling down a bit, remove the filter.
In order to put the filters in place after cleaning, follow the above instruc- tions in reverse order.
Carbon filter (used in recirculated air mode)
Carbon filter is designed to trap odors and fumes while cooking. It is used
in cases where there is no pos-sibility to connect the air cleaner to a
special ventilation duct for discharging air outward. When operating the
appli-ance with a carbon filter, contaminated air is sucked into the appliance
and passes through a carbon filter, and then clean air is supplied to the
kitchen.
The carbon filter should be replaced at regular intervals. The interval of filter replacement depends on the frequency of use of the air cleaner, style of cooking and frequency of the aluminum filter cleaning. Generally, it is recommended to replace the carbon filter once every 4 months.
How to remove carbon filter
- Remove aluminum filters.
- Turn the carbon filter to the left and pull it.
- Replace the old carbon filter with the new one.
- Put the filter back into place.
If necessary, clean the outside of the air cleaner with a soft, damp cloth. Do not use any abrasive cleaning agents. For painted stainless steel surfaces: to avoid scratching it is recommended to wipe them with a soft, damp cloth in the painting direction. Do not remove the lamp cover during the surface cleaning process.
Caution! Do not use the steam generators for cleaning.
Caution! Not following the above rules for cleaning the appliance and
replacing filters may cause fire.
Before replacing lamps, disconnect the appliance from the power supply. Then, with a screwdriver, pry and remove the lamp cover, while supporting it from below. Remove the burned-out lamp and replace it with a new one. Put the lamp cover into place, press it slightly and fix it. Caution: do not touch the halogen lamp with your fingers, it significantly reduces its lifetime. Use a soft, dry cloth.
Caution! If you need to transport the air cleaner, first of all,
disconnect it from the power supply and proceed with disassembly. It is
recommended that you transport it in the original packaging.
If this packaging is not available, pack-age the appliance using materials
that prevent possible damage resulting from transportation.
Troubleshooting
Very often a malfunction of the appli-ance occur for minor reasons. So, before you call for service center, please check whether you can troubleshoot yourself. For this purpose please check the fol-lowing possible causes of malfunctions.
Malfunction | Possible cause | Troubleshooting action |
---|
The appliance does not operate
| …Faulty fuse
…Plug is not properly inserted into the outlet
…There is no voltage in the power supply system
| 1. Check the fuse of the appliance
2. Make sure that plug is properly inserted into the
outlet
Suction power is not
sufficient
| …Incorrect speed selected
…Filters are clogged
| 1. Increase suction speed of hood
2. Clean or replace filters
The lamp is not lighting
|
…Faulty fuse
…The lamp is burned out or incorrectly installed
| 1. Check the fuse of the appliance
2. Make sure that the lamp is installed correctly or
replace it
Helpful information
Physical characteristics of the sound volume (the sound pressure level) is
measured in decibels (dB). «Noise» is a chaotic mix of sound.
The human ear can detect sounds with sound volume of 10-15 dB and above.
When choosing a kitchen hood, it is necessary to pay special attention to technical indicators such as the noise level. This indicator is very important, because, and that’s beyond a shadow of a doubt, each of us spends a lot of time on the kitchen. It is especially common for women who love to please their loved ones with delicious cooked dishes.
According to the surveys, 40% of women do not use kitchen hoods for their
intended purpose (it refers to the process of air suction), precisely because
they are annoyed with the noise level.
Consequently, such a necessary and needed in the kitchen appliance, kitchen
air cleaner, designed to remove airborne odors, grease, soot and smoke,
becomes almost meaningless.
This allows you to make the cooking process the most comfortable and helpful.
For more complete understanding of the scale of decibels, you can compare parameters of the following guidelines:
Intensity of typical noise sources
Approximate sound pressure level dB| Characteristics| Sound source and
distance
160| Shock, trauma| Shot of a gun of 0.303 caliber close to your ear
150| Contusion, trauma| Rise of the lunar rocket, 100 m
140| Contusion| Rise of the jet plane, 25 m
120| Almost unbearable| Engine room of submarine Jackhammer, 1 m
100| Extremely noisy| Very noisy factory Subway car (intermittently)
90
|
Very noisy
| Heavy diesel truck, 7 m
Road drill (without muffler), 7 m
Railway freight wagon, 7 m
80| Very noisy| Ringing alarm clock, 1 m Motorcycle with a silencer, 1 m
75| Noisy| Inside railway carriage Shout, 1 m Loud laughter, 1 m
70
|
Noisy
| Inside a small car, moving at a speed of 50 km/h Home vacuum cleaner, 3 m
Loud conversation, 1 m
65| Clearly audible| Typewriter Normal conversation, 1 m
40| Quite audible| Institution, where there are no special sources of noise
35| Hardly audible| Room of a quiet apartment
Very muffled conversation
25| Quiet| Rural areas located far from roads Whisper of a person, 1 m
Please note! The following shall not be considered as defects of the Product
Cooker hoods| Minor technical smells coming from a new product during the
initial operation period
---|---
Violation of the operating conditions of the components of the product, made
of natural wood
Sound of the air flow passing through the ventilation ducts and channels of
the product
Discoloration of housing elements of the product when using the product
Black discoloration and deformation of fat filter elements when using the
product
DETERMINATION OF THE PRODUCTION DATE BY SERIAL NUMBER:
Manufacturers:
M&G HAUSGERATE GMBH
Potsdamer Str. 92 10785 Berlin
Tel: (030) 544 37 834 Fax: (030) 544 37 856
Factories-branches of the manufacturer:
TRAOM ELEKTRIKLI ALETLER SAN.VE TIC.LTD.STI
Kumbet Hatun O.S.B Mah.3.Cad.No:17 Merzifon/Amasya/Turkiye
Ciarko Spółka z ograniczoną odpowiedzialnością Sp. K.
38-500 Sanok,ul.Okulickiego 10, Polska
Importers:
LLC «MG Rusland»,
141400, Moscow region, Khimki, Butakovo, 4
The manufacturer reserves the right to make any changes to design, outside
appearance and scope of supply of appliance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>