KUPPERSBERG NANCY 60 Extractor Hood Instruction Manual
- June 1, 2024
- Kuppersberg
Table of Contents
KUPPERSBERG NANCY 60 Extractor Hood
Specifications:
- Model: Nancy 60, Nancy S 60, Nancy S 90
- Manufacturer: M&G HAUSGERATE GMBH
- Dimensions:
- Nancy 60 : 300mm x 280mm x 562-862mm
- Nancy S 60, Nancy S 90 : 256mm x 80mm x 563-900mm
Product Usage Instructions
Safety Precautions:
Ensure the following safety measures:
- Avoid using other materials.
- For use with an electric stove: minimum distance of cm;
- For use with a gas or gas-electric stove: minimum distance of 70cm.
Installation and Dimensions:
When operating the extractor hood in exhaust mode, ensure the installation of an air duct with the appropriate diameter to prevent performance loss due to air resistance.
Cleaning and Maintenance:
Aluminum Filter:
To remove the aluminum filter, follow these steps:
- Remove the aluminum filter.
- Turn the charcoal filter to the left and pull it towards you.
- Replace the used charcoal filter with a new one.
- Reinsert the aluminum filters.
Charcoal Filter (for recirculation mode):
It is recommended to replace the charcoal filter every 4 months on average.
Troubleshooting:
If you encounter issues like insufficient suction power or non-functional lights, ensure proper installation and check for any errors as per the manual.
FAQ:
- Q: How often should I replace the charcoal filter?
- A: It is recommended to replace the charcoal filter approximately every 4 months for optimal performance.
- Q: What safety precautions should I consider during installation?
- A: Avoid using materials other than those recommended and ensure proper distances from different types of stoves as indicated in the manual.
DEAR CUSTOMER,
Thank you for purchasing our equipment! We are sure that appliances of the KUPPERSBERG brand, which are modern, functional, and made of high-quality materials and components, will be a reliable assistant in your kitchen.
Please read this manual carefully before starting any installation work. It
will help you avoid premature failure, as well as extend the life of your
appliance to the maximum possible.
Please note that the installation of this appliance must be carried out by a
qualified technician and in accordance with these instructions. The
manufacturer is not liable for any consequences of failure to observe this
condition.
Caution!
The manufacturer reserves the right to make any changes, without prior no- tice, to design, outside appearance and scope of supply of the appliance, which will be considered as necessary and useful according to the manufacturer’s point of view. Possible modifications will not affect the basic properties, including those that relate to safe operation of the appliance.
Extractor hood
SECTION 1.
SAFETY PRECAUTIONS
- Assembling and electrical con-nection of the appliance must be carried out by skilled technicians of an authorized service center.
- The appliance is designed to operate on 220-240 V AC. Make sure that the technical parameters of your home power supply system correspond to the data for the power supply. If parameter values are above or below the specified range, the use of the appliance is prohibited.
- Do not connect the kitchen air cleaner to the ventilation channels that are used to remove smoke and fumes from the equipment operating on any other energy sources except electric one.
- The appliance is to be connected only to an earthed power supply system.
- Do not cook flammable foods be-low the kitchen air cleaner.
- Use the aluminum filter that comes with the appliance. The use of other materials is prohibited!
- Do not connect the appliance to the power supply system, until the as-sembly and installation of the appliance is completed.
- Do not use the appliance without the aluminum filter in place.
- Do not touch the lamps.
- Do not remove the aluminum filters while the appliance is in operation.
- Do not disconnect the appliance from the power supply system directly. If necessary, turn the appliance off using the control panel and, only after that, unplug it from the power supply system. When switching on: first connect the appliance to the power supply system, then switch it on using the control pan-el, but not vice versa!
- The appliance requires regular cleaning and maintenance work.
- When installing the appliance, observe the required distance between it and the cooking surface of your stove:
- for an electric stove: at least 65 cm— for a gas or gas-electric stove: at least 70 cm
- Do not allow children to play with packaging materials, it can be dan-gerous!
- For best air cleaning in your kitchen, do not turn off the appliance immediately after the cooking process is completed: let the appliance run for a further 15 minutes. For this purpose, you can also use the timer function (the button «Auto Switch Off Timer» on the control panel).
- Ensure adequate ventilation in the kitchen, if a gas stove is operated simultaneously with the appliance.
- In case of any malfunctions, con-tact your nearest authorized service center.
- If the kitchen hood is supposed to operate in air discharge mode, then during installation it is important to provide a duct of the corresponding diameter. To prevent loss of performance caused by aerodynamic resistance of the duct, the air duct must not be too long, or curved. Never restrict the duct size, or make sharp bends. In addition, it is preferable to use a smooth PVC duct (round or flat), rather than the flexible corrugated one because bends of a corrugated duct increase the noise level of the hood.
- The manufacturer does not bear any responsibility for any possible damage, in case of non-compliance with the above precautions.
SECTION 2.
SPECIFICATIONS BUILT-IN HOOD
-
Width ………………………………
-
600mm (NANCY 60, NANCY S 60), 900mm (NANCY S 90)
Diameter of the air -
discharge pipe ……………… 120-150 mm
-
Voltage…………………………… 220-240 V / 50 Hz
-
Modes of operation ……… Air discharge / Recirculation
-
Noise level ……………………. min. 58 dB- max. 62 dB
-
Lamps………. LED 2×2
SECTION 3. CONTROL TYPE NANCY 60
- A – On/Off switch
- B – Power speeds
- C – Lighting
- D – Auto Switch Off Timer
- A – Hood motor On/Off
- B – Power speeds (4 speeds+ Turbo): Press on these switches, and the motor runs at LOW-HIGH speeds.
- C – Lighting: Press on this switch to turn on the lights, and press again to turn them off.
- D – Auto Switch Off Timer : When you press on the Timer, the motor will automatically be shut down after 15 minutes. To cancel, press once on the Timer.
- Number of speeds : 4 speed + TURBO. When the turbo button is pressed, the turbo will run for 5 minutes. After 5 minutes, it will go back to the 4th revolution.
NANCY S 60, NANCY S 90
- А – On/Off switch
- В – Power decrease
- С – Display
- D – Power increase
- E – Auto Switch Off Timer F – Lighting
- А – Hood motor On/Off
- В – Motor rotation speed decrease (suction power reducing)
- С – Display shows motor rotation speed
- D – Motor rotation speed increase (suction power increasing)
- E – When you press on the Timer, the motor will automatically be shut down after 15 minutes. To activate the function, press and hold the Timer for 3 seconds (the rotation speed level starts to flash on the display). To cancel, press once on the Timer.
- F – Lighting On/Off
Number of speeds : 4 speed + TURBO. When the turbo button is pressed, the turbo will run for 5 minutes. After 5 minutes, it will go back to the 4th revolution
SECTION 4. MOUNTING AND DIMENSIONS
Please unpack and inspect the ap- pliance! Before starting installation, make sure that the hood has no obvious transport damages. If such defects are detected, do not install or connect the appliance to the mains.
To comply with safety regulations, the distance between the cooking sur-face and the air cleaner should be 700 mm.
SECTION 5. CLEANING AND MAINTENANCE
aution! Before you start clean-ing the appliance, disconnect it from the power supply.
ALUMINUM FILTER
Aluminum filter is designed to trap grease particles out of the flow of air
running through it. For this reason, the filter needs regular cleaning. The
cleaning intervals depend on the frequency of use of the air cleaner.
Generally, it is recom-mended to clean it once a month.
To do this, remove the filters, wash them in water with a neutral liquid
detergent, dry them, then set them back in the air cleaner. Over time, filters
may change color due to a regular washing. This is a natural process, which
does not indicate a defect, so filter replacement is not required.
The aluminum filters can be washed in the dishwasher.
HOW TO REMOVE ALUMINUM FILTERS:
- Press on the latch of the filter lock.
- Pulling down a bit, remove the filter. In order to put the filters in place after cleaning, follow the above instructions in reverse order.
CARBON FILTER (USED IN RECIRCULATED AIR MODE)
A carbon filter is designed to trap odors and fumes while cooking. It is used
in cases where there is no possibility to connect the air cleaner to a special
ventilation duct for discharging air outward. When operating the appliance
with a car-bon filter, contaminated air is sucked into the appliance and
passes through a carbon filter, and then clean air is supplied to the kitchen.
The carbon filter should be replaced at regular intervals. The interval of
filter replacement depends on the frequency of use of the air cleaner, style
of cook-ing and frequency of the aluminum filter cleaning. Generally, it is
recommended to replace the carbon filter once every 4 months.
HOW TO REMOVE CARBON FILTER:
- Remove aluminum filters.
- Turn the carbon filter to the left and pull it.
- Replace the old carbon filter with the new one.
- Put the filter back into place.
If necessary, clean the outside of the air cleaner with a soft, damp cloth. Do not use any abrasive cleaning agents. For painted stainless steel surfaces: to avoid scratching it is recommended to wipe them with a soft, damp cloth in the paint-ing direction. Do not remove the lamp cover during the surface cleaning process.
Caution!
Do not use the steam generators for cleaning.
Caution!
Not following the above rules for cleaning the appliance and replacing fil- ters may cause fire.
REPLACING LAMPS
Before replacing lamps, disconnect the appliance from the power supply. Then, with a screwdriver, pry and remove the lamp cover, while supporting it from below. Remove the burned-out lamp and replace it with a new one. Put the lamp cover into place, press it slightly and fix it. Caution: do not touch the halogen lamp with your fingers, it significantly reduces its lifetime. Use a soft, dry cloth.
Caution!
If you need to transport the air clean-er, first of all, disconnect it from the pow-er supply and proceed with disassembly.
It is recommended that you transport it in the original packaging. If this packaging is not available, package the appliance using materials that prevent possible damage resulting from transportation.
SECTION 6. TROUBLESHOOTING
Very often a malfunction of the appli-ance occur for minor reasons. So, before you call for service center, please check whether you can troubleshoot yourself. For this purpose please check the follow-ing possible causes of malfunctions.
SECTION 7. HELPFUL INFORMATION
Physical characteristics of the sound volume (the sound pressure level) is
measured in decibels (dB). «Noise» is a chaotic mix of sound.
The human ear can detect sounds with sound volume of 10-15 dB and above.
When choosing a kitchen hood, it is necessary to pay special attention to technical indicators such as the noise level. This indicator is very important, because, and that’s beyond a shadow of a doubt, each of us spends a lot of time on the kitchen. It is especially common for women who love to please their loved ones with delicious cooked dishes.
According to the surveys, 40% of women do not use kitchen hoods for their
intended purpose (it refers to the process of air suction), precisely because
they are annoyed with the noise level.
Consequently, such a necessary and needed in the kitchen appliance, kitchen
air cleaner, designed to remove airborne odors, grease, soot and smoke,
becomes almost meaningless.
This allows you to make the cooking process the most comfortable and helpful.
For more complete understanding of the scale of decibels, you can compare the
parameters of the following guidelines:
Please note!
The following shall not be considered as defects of the Product
SERIAL NUMBER:
MANUFACTURERS:
- M&G HAUSGERATE GMBH
- Potsdamer Str. 92 10785 Berlin
- Tel : (030) 544 37 834
- Fax: (030) 544 37 856
FACTORIES-BRANCHES OF THE MANUFACTURER:
TRAOM ELEKTRIKLI ALETLER SAN.VE TIC.LTD.STI
Kumbet Hatun O.S.B Mah.3.Cad.No:17 Merzifon/Amasya/Turkiye
IMPORTER:
LLC «MG Rusland», 141400, Moscow region, Khimki, Butakovo, 4
The manufacturer reserves the right to make any changes to design, outside appearance, and scope of supply of the appliance.
Kuppersberg