WOODCRAFT IN45-0760F Front Axle Sliders Aprilia Instruction Manual

October 27, 2023
WOODCRAFT

WOODCRAFT - logo

IN45-0760F Front Axle Sliders Aprilia
Instruction Manual

IN45-0760F Front Axle Sliders Aprilia

Important Note: Sometimes axles are damaged when hammered in and will slightly deform the axle itself. Since our axle sliders are a precise fit, you will need to file off any raised edges. You will not need to do this on an axle in good condition.
Assembly and installation of this kit does not require the removal of the front axle.

  1. The larger base will be installed inside the hex of the axle itself. To install the base, thread the 6mm x 45mm socket head bolt into the assembly until it is almost tight, leaving a small gap between the halves. Slide the assembly into the round hole of the axle and be sure that it is fully seated against the axle. Tighten the 6mm allen bolt (8 ft lb) to lock the assembly in place.
    WOODCRAFT IN45-0760F Front Axle Sliders Aprilia

  2. Install the plastic hex puck using the removable pin. Important: the puck has a small hole drilled beneath the main hole. Install the pin so that One side of the end of the pin with the ball is on the same side as this small hole.

  3. On the nut side, insert the hex adapter into the puck and to be sure that the hole is lined up properly (see below). The pre-assembled axle slider will have the correct orientation already.
    WOODCRAFT IN45-0760F Front Axle Sliders Aprilia - fig
1

  4. Repeat steps 1-2 above for the smaller nut side axle slider with the 6mm x 25mm bolt.WOODCRAFT IN45-0760F Front Axle Sliders Aprilia - fig 2

A note for racers: If your tech inspector wants you to safety wire these (most will not) then you simply need to orient the pins so that the pull on the pin is both clockwise and down (so that it acts to tighten the bolt and pull the pin into the puck)
105 Baldwinville Rd, Winchendon, MA 01475 978-297-2977
WARNING: Improper installation and/or failure to comply with all warnings and instructions may cause a loss of control and serious injury or death. The motorcycle should be run and thoroughly inspected before use. DO NOT INSTALL OR USE THIS PRODUCT IF YOU ARE UNABLE TO DO SO IN COMPLIANCE WITH ALL INSTRUCTIONS AND WARNINGS. SEEK THE ASSISTANCE OF A TRAINED PROFESSIONAL TECHNICIAN.WOODCRAFT - logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals