WOODCRAFT 60-0760RB Clutch Cover Protector Instruction Manual
- June 4, 2024
- WOODCRAFT
Table of Contents
Installation Instructions
60-0760RB Clutch Cover Protector
-
Attach the skid plate to the Woodcraft cover by bolting it from the inside using the 5mm flathead bolts. The 60-2500 rubber pad should also adhere to the back side of the cover.
IMPORTANT USE
THREAD LOCKING COMPOUND ON THE THREE SKID PLATE MOUNTING BOLTS. Coat the threads completely and allow the thread-locking compound to fully set before use. -
Install the Woodcraft cover with a using the included mounting hardware in the 4 locations shown at the right. The 6mm washer goes between the cover and the engine at the 2nd bolt location, counting from the left side. Torque for the main 6mm mounting bolts is about 7 ft-lbs.
-
Start the motorcycle and inspect for any leaks before riding.
|
---|---
WARNING
Installation of Woodcraft Billet Covers involve removal and reinstallation of certain factory components such as fasteners, alternator stators, and oil- retention gaskets. FAILURE TO INSTALL THESE COMPONENTS IN COMPLIANCE WITH ALL SPECIFIC INSTRUCTIONS SUPPLIED WITH BILLET COVER KIT, MAY CAUSE OIL LOSS OR DAMAGE TO ENGINE RESULTING IN LOSS OF CONTROL OF MOTORCYCLE AND SERIOUS INJURY OR DEATH.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>