WOODCRAFT 77E50 Pep-per Professional Grinder Kits User Manual
- June 5, 2024
- WOODCRAFT
Table of Contents
WOODCRAFT 77E50 Pep per Professional Grinder Kits
Adjustable Length Salt or Pepper Professional Grinder Kits
Supplies Needed to Complete Kit
- 7/8 Forstner Bit Cap
- 11/16 Forstner Bit Through Bore Body
- 11/2″ Forstner Bit Second Step Bore
- 13/4″ Forstner Bit First Step Bore
- Forstner Bit Extensions 4 or 6 lengths needed for taller mills
- 3 x 3 x 12 Turning Stoc
- Lath
- Jamb Chucks
- Turning Tool
- Drill Press or Lathe Drill Chuck
- Sandpaper
- Eye & Ear Protectio
- Dust Mask
Boring/Turning/Shaping the Mill
- Mark centers on both the body and cap. If using the lathe to bore, mount the body using a 4-jaw chuck.
- Using the lathe drill chuck, begin by boring a 13/4 diame-ter hole 3/4 deep.
- Bore a 11/2diameter hole 13/8 deep for a total depth of 21/8
- Bore a 11/16 diameter hole through the remain portion of the body.
- Mount cap blank and bore a 7/8 diameter hole 11/4 deep.
- Create a jamb chuck to fit snuggly into the 13/4 bore.
- Mount the body onto the jamb chuck and secure between centers using a large live center.
- Turn, Sand up to 320 grit, and apply a food safe finish of your choice.
- Create a jamb chuck to fit snuggly into the 7/8 bore.
- Mount the cap onto the jamb chuck and secure between cen-ters using a live center.
- Turn, Sand up to 320 grit, and apply a food safe finish of your choice.
Dimension Notes
The dimensions shown below are the bore diameters for the body and cap of the grinder. The outside dimensions will vary to suit your design, but the wall thickness should be at least 1/4. The overall finished length, body and cap will vary, depending on the chosen finished length, up to 12 length.
Assembly
Note
Mechanism is designed to fit in Metric holes. Modifications will be necessary
for Imperial size holes.
- With a sharp knife or chisel, remove the six ribs around the base of the mechanism. Removal of the edges of the clips may be necessary.
- Insert Mechanism (A) into Turned Body pushing firmly into place. Measure 11/8 up from the top of the turned body and make a mark.
- Remove Mechanism (A) and cut the drive shaft to length.
- Apply epoxy to the body of the mechanism, avoiding any moving parts. Insert Mechanism A into Turned Body pushing firmly into place till bottoming out.
- Apply epoxy to Knob Mechanism (B) and insert into Turned Cap.
- Once epoxy has cured install Turned Cap onto drive shaft press firmly into place.
- To adjust coarseness of grind, rotate dial clockwise for a finer grind or counter clockwise for a more coarse grind.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>