WOODCRAFT 60-0417WPC Yamaha Water Pump Cover Protector Instruction Manual
- June 3, 2024
- WOODCRAFT
Table of Contents
WOODCRAFT 60-0417WPC Yamaha Water Pump Cover Protector
Installation Instructions
60-0417WPC Yamaha R7/FZ07/MT07 Water Pump Cover
-
Attach the skid plate to the Woodcraft cover by bolting it from the inside.
IMPORTANT – USE BLUE THREAD LOCKING COMPOUND ON THE THREE SKID PLATE MOUNTING BOLTS. Coat the threads completely and allow the thread-locking compound to be fully set before use. -
Be sure that the rubber pad adheres to the back of the cover in the pocket just above the bolt locations.
-
Install the Woodcraft cover using the included mounting hardware. The torque for these mounting bolts is about 7 ft-lbs. The location of each bolt and a disgram showing the 4 bolts used for this installation is shown at the right. We were able to replace the water pump bolts without losing any coolant, but it is advisable to put a drain pan under the bike in case there is any leakage.
-
Start the motorcycle and inspect for any leaks before riding.
WARNING
Installation of Woodcraft Billet Covers involves removal and reinstallation of
certain factory components such as fasteners, alternator stators and oil-
retention gaskets. FAILURE TO INSTALL THESE COMPONENTS IN COMPLIANCE WITH ALL
SPECIFIC INSTRUCTIONS SUPPLIED WITH THE BILLET COVER KIT, MAY CAUSE OIL LOSS
OR DAMAGE TO THE ENGINE RESULTING IN LOSS OF CONTROL OF THE MOTORCYCLE AND
SERIOUS INJURY OR DEATH.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>