HAMRON 015033 Music Controlled LED Strips Instruction Manual
- June 5, 2024
- HAMRON
Table of Contents
HAMRON 015033 Music Controlled LED Strips
SAFETY INSTRUCTIONS
- Have the product installed by a professional automotive electrician if in doubt. The product must not be installed in vehicles with defective electrical systems. Do not make any modifications to the product.
- Do not install and use the product if it can in any way put the road safety of the vehicle at risk. Follow the instructions of the vehicle manufacturer for correct and safe installation.
- The manufacturer cannot accept liability for personal injury, material damage, consequential loss or any other loss resulting from incorrect installation or improper use of the product. Follow the applicable laws and rules and regulations concerning automotive parts and accessories.
WARNING!
Failure to follow all the instructions and safety instructions can result in a
risk of personal injury and/or material damage.
SYMBOLS
- Read the instructions.
- CE : Approved in accordance with the relevant directives.
- Recycle discarded product in accordance with local
TECHNICAL DATA
- Output 9×0.2 W
- Voltage 12 V
- Cable length 7.6 m
- Size of LED strip L 17 cm
- Colour of LED strip RGB/Multicolour
DESCRIPTION
PARTS
- Remote control
- IR receiver
- IR control unit
- Adapter for 12 V socket
- LED strips
REMOTE CONTROL
- Increase/reduce brightness
- 8 colour options
- Colour jump
- Power switch
- Colour toning
- 4 music synchronisation modes
NOTE:
- Adjust the volume – synchronisation with the music is automatic.
- Always point the remote control directly at the IR receiver. Make sure there are no obstructions between the remote control and the IR receiver
- Remove the protective film on the battery before using the remote control
INSTALLATION
- Put the 12 V adapter in the 12 V outlet in the vehicle. Test the product before installation. Connect to voltage and press the buttons to test all the light sources.
- Decide where to install
- Carefully clean the mounting surfaces. The self-adhesive surfaces will not fasten if there is any residual dirt, wax, grease or oil etc.
- Fit the LED strips on the selected mounting surfaces. Plan routing the cables so that they do not touch or go near warm or moving parts.
- Carefully remove the protective film from the back of the LED strips, place the light strips on the selected surfaces and press in place.
- Conceal the cables under mats or panels.
- Make sure that the 12 V socket is supplied with voltage by testing the product.
- Press the 4 buttons for different music synchronisation modes and play music to test the synchronisation. The IR receiver can be placed beside the 12 V socket or on the centre console.
NOTE
- For best results the temperature when fitting the LED strips should be between 21 and 32° C. At low ambient temperatures the LED strips or mounting surfaces should be warmed with a hair dryer.
- The product is not DOT approved and is only intended for indoor use. The product must not be used in extreme temperatures, such as in the engine bay.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>