HAMRON 016039 Light Bar LED Instruction Manual
- June 4, 2024
- HAMRON
Table of Contents
HAMRON 016039 Light Bar LED
Care for the environment!
Recycle discarded product in accordance with local regulations.
Jula reserves the right to make changes. For latest version of operating instructions, see www.jula.com
- Read these instructions carefully before installation and save them for future.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
SYMBOLS
| Read the instructions.
CE| Approved in accordance with the relevant directives.
| Recycle discarded product in accordance with local regulations.
TECHNICAL DATA
- Rated voltage 9-36 VDC
- Light source 27×5 W LED
- Output 135W
- Luminous flux 12200 Im
- Colour temperature 6000 K
- Range 1Iuxat491m
- Range 0.25 lux at 982 m
- Protection rating IP68
- Cord length 50cm
- E-approved Yes
- ETM* Yes
- Size W763 x H40.5 x D52.5 mm
- Weight 2 kg
Electronic thermal management
DESCRIPTION
Slim extra lighting that makes driving safer and less tiring. Hamron’s slim
light bar produces a more discrete impression and a stylish look. It has 27 x
5 W LED light sources that deliver 12200 theoretical lumen and 10370 actual
lumen. The beam is a so-called Combo beam,which means that the light bar
produces a powerful spot beam a long way ahead on the road, while diffuse
reflectors on the sides create a wide and uniform beam to provide light on the
sides of the road. LED light sources have electronic thermal monitoring (ETM),
which retains the intensity of the diodes and avoids discolouring if the heat
becomes excessive. Adapter for fixed installation and mounted on the supplied
bottom or side fasteners made of stainless steel. Installation accessories and
DT connector included.
FIG. 1
BEAM
- Diffusion angle
- Metres
FIG. 2
ETM
Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is
maintained and discolouring is avoided if the heat becomes excessive.
INSTALLATION
-
Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from shortcircuiting during the installation.
-
Follow as far as possible the existing cable routing for installation of new cables.
Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts. -
Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
-
The product can be mounted with side (1) or bottom (2) fasteners. Put the screws in the holes, put on the lock washers and tighten the nuts.
FIG. 3
Cable colour coding
The OT connector’s red wire is(+) and the black wire is(-).
WARNING
- The product must only be used within its rated voltage range, 9 to 36 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>