universal douglas VLA Recessed Lay-In Volumetric Luminare Instruction Manual
- June 3, 2024
- universal douglas
Table of Contents
universal douglas VLA Recessed Lay-In Volumetric Luminare Instruction
Manual
IMPORTANT SAFETY INFORMATION
SAFETY WARNINGS
Risk of injury or damage. Mount only to a mechanically sound surface; All fixtures must be connected to a grounded, three-wire supply; All electrical connections must be capped with UL listed wire connectors rated 600V or higher; If supply wires are located within three inches of the LED driver, use wire rated for at least 90°C; Consult qualified electrician before installing.
Follow information on label & instructions regarding installation near combustible materials, insulation, and building materials &in Dry or Wet locations. Do not install in areas exposed to combustible vapors or gases.
This product must be installed by a person familiar with construction and operation of the product and the hazards involved, in accordance with the applicable installation. Be sure to ground product to avoid potential electrical Shock or Other potential hazard. Use of accessory equipment not recommended by manufacturer or installed inconsistent with instructions may cause an unsafe condition. Do not completely or partially block light emerging from product, as this could cause an unsafe condition. Do not allow other items to come into contact with the product, as this may cause an unsafe condition. This product may contain chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash your hands after installing, servicing, handling, cleaning, or otherwise touching this product. This device complies with FCC CFR Title47 Part 15, Class A requirements for EMI/RFI.
INSTALLATION
APPLICATION ADVICE
- Do not touch LED diodes or connecting clips on the LED modules.
- This product is intended for application in indoor, dry and non-corrosive environments.
Read More About This Manual & Download PDF: