universal douglas PLA Recessed Lay-In Volumetric Luminaire Instruction Manual

June 3, 2024
universal douglas

INSTALLATION INSTRUCTIONS
PLA RECESSED LAY-IN VOLUMETRIC LUMINAIRE
14044300 Rev. A

SAFETY WARNINGS

IMPORTANT SAFETY INFORMATION
  Before you begin. Read these instructions completely & carefully.
WARNING Risk of electrical shock. Disconnect power before servicing or installing the luminaire.
WARNING Risk of injury or damage. The luminaire will fall if not installed properly. Follow installation instructions, NEC and local codes and best trade knowledge.
WARNING Risk of injury. Wear safety glasses and gloves during installation and servicing.

WARNING Risk of injury or damage. Mount only to a mechanically sound surface; All fixtures must be connected to a grounded, three-wire supply: All electrical connections must be capped with UL-listed wire connectors rated 600V or higher; If supply wires are located within three inches of the LED driver, use wire rated for at least 90°C; Consult qualified electrician before installing.
Follow the information on the label & instructions regarding installation near combustible materials, insulation, and building materials & in Dry or Wet locations. Do not install in areas exposed to combustible vapors or gases. This product must be installed by a person familiar with the construction and operation of the product and the hazards involved, in accordance with the applicable installation. Be sure to ground the product to avoid potential electrical shock or another potential hazard. Use of accessory equipment not recommended by the manufacturer or installed inconsistent with instructions may cause an unsafe condition. Do not completely or partially block light emerging from the product, as this could cause an unsafe condition. Do not allow other items to come into contact with the product, as this may cause an unsafe condition. WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects and/or other reproductive harm. Thoroughly wash your hands after installing, servicing, handling, deaning, or otherwise touching this product. This device complies with FOC CFR Title 47 Part 15, Class A requirements for EMURFI.

INSTALLATION

Step 1: Unpack & Inspect
Carefully remove the fixture from the packaging. Use gloves to prevent dirt and oils from transferring to the unit. Inspect the fixture for any defects before proceeding. Confirm the product ordered matches the product received
Step 2: Attach Grid-Clips and Lay-In Fixture
CAUTION: EDGES MAY BE SHARP: Attach grid clips (four locations) and gently lower the fixture into the grid, ensuring the grid clips engage the T-bar.

Step 3: Attached Slack Wires
Attach slack wires (four locations) if desired or if required by local building codes

Step 4: Remove Access Plate Use a screwdriver to remove the access plate. Reach in and pull the ends of the fixture wires through the hole in the fixture. Take care to avoid abrading fixture wires. Step 5: Make Electrical Connections
Remove a pry-out, route the metal-clad cable and secure to the access plate. Make electrical connections: Line to black, neutral to white and earth ground to the screw on the access plate.

Step 6: Replace Cover Plate & Test
CAUTION: EDGES MAY BE SHARP: Install access plate, apply power and confirm normal operation

APPLICATION ADVICE

  • Do not touch LED diodes or connecting clips on the LED modules.
  • This product is intended for application in indoor, dry, and non-corrosive environments with a maximum operating ambient temperature of 25C.

www.universaldouglas.com
Rev. 3/15/22
Universal Lighting Technologies

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

universal douglas User Manuals

Related Manuals