kaptel BLAST U6 GigaSpire System User Guide
- June 5, 2024
- kaptel
Table of Contents
kaptel BLAST U6 GigaSpire System
Setting up your BLAST u4m
-
Connect BLAST u4m to power outlet.
-
When the LED is flashing red, you can pair the BLAST u4m with the BLAST u6. Press and hold the WPS buttons on the BLAST u4m and then the BLAST u6 for 3 seconds each (less than 30 seconds apart). The LED flash green while attempting to pair. Note: Once successful pairing is complete, the BLAST and GigaMesh LEDs will both show a solid cyan (light blue) colour. It may take several minutes to reach this state.
-
Use the solid green LED indicator (displays for 60 seconds at end of pairing cycle) to determine ideal location for the GigaMesh. If necessary, relocate it to a more ideal distance from the BLAST and confirm successful pairing after the GigaMesh reboots (repeating steps 2-3 as needed).
-
If applicable, use the Command IQ app to set up the BLAST. See the CommandlQ Quick Start Guide for guidance.
NEED HELP?
Contact us by phone at 337.643.7171, email at
hello@kaptel.net, or online chat at
kaptel.net.
