AViANCE HD76945 Alden 23.5 in 3 Light Polished Brass ADA Vanity Light Instruction Manual

Table of Contents

AViANCE-HD76945-Alden-23-5-in-3-Light-Polished-Brass-ADA-Vanity-Light-
PRODUCT

Specifications:

Assembling the Fixture:

Switch off the power at the circuit breaker box and remove old fixtures and hardware from the Junction Box.
Unpack the new fixture and lay out all parts. Thread mounting screws into the pre-drilled holes in the mounting plate and attach it to the junction box.
Guide supply wires through the hole in the mounting plate and attach the back plate of the lamp body onto the junction box.
Install light bulbs according to specifications without exceeding the maximum wattage rating.

Connecting the Wires:

Connect the Black wire from the fixture to the black house (hot) wire, and the white wire from the fixture to the white (neutral) house wire. Secure all wire nuts and wrap connections with electrical tape if needed.
If your junction box has ground wires, connect the fixture’s ground wire accordingly. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck wire connections neatly into the wall junction box.

Your installation is now complete. Restore power to the junction box and test the fixture.

FAQ:

Q: What should I do if I lose small parts during installation?
A: If you lose small parts necessary for installation, please contact customer service at info@aviancelighting.net for assistance with replacement parts.
Q: Can I use light bulbs of any wattage with this fixture?
A: No, it is important not to exceed the maximum wattage rating specified for the fixture to avoid damage or hazards.

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. HD60562

WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

$AViANCE-HD76945-Alden-23-5 in 3-Light-Polished- Brass-ADA-Vanity-Light-FIG- $1$$

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Thread the two mounting screws about 1/4” into the pre-drilled holes in the mounting plate, spaced about the same distance apart as the holes in the fixture back plate. Attach the mounting plate to the junction box using two junction box screws as shown. The side of the single bar marked “GND” must face out. The junction box is not included.
Guide supply wires through the hole in the centre of the mounting plate. Follow wiring instructions carefully (see Fig. 2).
Attach the back plate of the lamp body onto the junction box, aligning the back plate’s hole with the mounting screw, and lock it securely with the ball nuts.
Install the light bulbs(Not included) by the fixture’s specifications. DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

$AViANCE-HD76945-Alden-23-5 in 3-Light-Polished- Brass-ADA-Vanity-Light-FIG- $2$$

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your junction box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box. Your installation is now complete. Return power to the junction box and test the fixture.