AViANCE Lighting HD84063 Chadbdurne 5 Inch 1-Light Polished Brass Wall Vanity Light Installation Guide

Table of Contents

Vanity Light

Assembling & Installation Instructions

Connecting the Wires

Connect the electrical wires as follows:
- Black wire from the fixture to the black house (hot) wire.
- White wire from the fixture to the white (neutral) house wire.
- If there are ground wires, connect the fixture’s ground wire accordingly.
Secure all wire connections with wire nuts and consider wrapping them with electrical tape for safety.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Restore power to the junction box and test the fixture.

Q: What should I do if my outlet box does not have a ground wire?
A: In that case, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Q: How can I get assistance with parts or assembly?
A: Please email customer service at: info@aviancelighting.net with your query.

The drawing shown may not exactly match the product enclosed.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
Thread the two mounting screws about 1/4” into the pre-drilled holes in the mounting plate, spaced about the same distance apart as the holes in the fixture back plate. Attach the mounting plate to the junction box using two junction box screws as shown. The side of the mounting plate marked “GND” must face out. The junction box is not included.
Guide fixture wires through a hole in the centre of the mounting plate.
Follow wiring instructions carefully. (see fig.2)
Raise the lamp body (A) onto the mounting plate, aligning the mounting holes with mounting screws, then lock it securely with the ball nuts (D).
Attach the shade(B) to the lamp holder, using the check ring(C) by turning it clockwise until tight.
Install the light bulbs (Not included) per the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

AViANCE-Lighting-HD84063-Chadbdurne-5-Inch-1-Light-Polished-Brass-Wall-
Vanity-Light-FIG-1

CONNECTING THE WIRES (Fig.2)

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

AViANCE-Lighting-HD84063-Chadbdurne-5-Inch-1-Light-Polished-Brass-Wall-
Vanity-Light-FIG-2