AViANCE Lighting HD82953 Body Lamp Instruction Manual

Table of Contents

Assembling & Installation Instructions:

The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.

WARNING! SHUT POWER OFF AT THE FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

Assembling the Lamp Body (Fig.1):

Shut off the power at the circuit breaker box. Remove the old lamp body and all hardware from the Junction Box.
Carefully unpack your new lamp body and lay out all the parts.

Connecting the Wires (Fig.2):

Connect the electrical wires as follows:
- Connect the Black wire from the lamp body to the black house (hot) Wire.
- Connect the white wire from the lamp body to the white (neutral) house wire.
- Make sure all wire nuts are secured. You may wrap the connections with electrical tape.
- If your outlet box has a ground wire (green or bare copper), connect lamp body’s ground wire to it. Otherwise, attach the bare copper lamp body wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the lamp body.

FAQ

Q: How do I contact customer service for assistance with parts or assembly?
- A: Please email customer service at: info@aviancelighting.net
WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

ASSEMBLING THE LAMP BODY (Fig.1)

AViANCE-Lighting-HD82953-Body-Lamp-fig1

Shut off the power at the circuit breaker box. Remove old lamp body and all hardware from the Junction Box.
Carefully unpack your new lamp body and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Thread the two mounting screws about 1/4” into the pre-drilled holes in the mounting plate, spaced about the same distance apart as the holes in the lamp body back plate. Attach the mounting plate to the junction box using two junction box screws as shown. The side of the mounting plate marked “GND” must face out. The junction box is not included.
Guide lamp body wires through the hole in the center of the mounting plate.
Follow wiring instructions carefully (see Fig. 2)
Raise the lamp body(A) onto the mounting plate, aligning the mounting holes with mounting screws, then lock it securely with the column nuts(B).
Install the light bulbs(not included) in accordance with the lamp body’s specifications.
- NOTE : DO NOT EXCEED THE MAXIMUN WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

AViANCE-Lighting-HD82953-Body-Lamp-fig2

Connect the electrical wires as follows. Connect the Black wire from the lamp body to the black house (hot) Wire. Connect the white wire from the lamp body to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wire (green or bare copper) connect the lamp body’s ground wire to it. Otherwise, attach the bare copper lamp body wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the lamp body

Thank you for purchasing an AVIANCE product.

Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net