AViANCE HD66922 Light Polished Chrome Instruction Manual
- June 1, 2024
- AVIANCE
Table of Contents
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
HD66922
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box. Carefully unpack your new fixture and lay out
all the parts on a clear area. Take care not to lose any small parts necessary
for installation.
2. Drilling two holes in the wall, distance and the same distance from
the keyhole of mounting plate, then loaded plastic anchors. Attach the
mounting plate to the wall, aligning the plastic anchors and junction box,
lock it securely with the two wood screws and the two box screws. The side of
the mounting plate marked “GND” must face out. The junction box is not
included.
3. Guide fixture wires through hole in center of mounting plate.
4. Follow wiring instructions carefully (see fig.2).
5. Place the fixture body (C) over the mounting plate, aligning the
backplane holes with screw hole of the mounting plate in side, then lock it
securely with mounting screws.
6. Raise the glass shade(B) insert the lamp holder, lock it securely with
the check ring(A).
7. Install the light bulbs(Not included) in accordance with the
fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from
the fixture to the black house (hot) Wire. Connect the white wire from the
fixture to the white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical tape. If your outlet box
has a ground wires (green or bare copper) connect fixture’s ground wire to it.
Otherwise attach the bare copper fixture wire to the green ground screw on the
mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
FIG.1
- Fixture Ground Wire
- Fixture wire
- Supply Ground Wire
- Junction Box (Not included)
- Supply wire
- Plastic Anchors
- Mounting Plate
- Wood screw
- Box screw
- Mounting screw
FIG.3
- FIXTURE WIRES Black or Smooth
- FIXTURE WIRES White or Ribbed
- FIXTURE WIRES Bare Copper (Ground)
- HOUSE WIRES Black(Hot)
- HOUSE WIRES White (Neutral)
- HOUSE WIRES Green or Bare Copper(Ground)
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service
at:info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.
DOC20240HD66922
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>