AViANCE Lighting HD81826 5.25 Inch 2-Light Brushed Gold Wall Sconce Installation Guide

Table of Contents

AViANCE-Lighting-HD81826-5-25-Inch-2-Light-Brushed-Gold-Wall-Sconce-
product

Specifications

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
Attach the mounting plate to the junction box using two junction box screws.

Connecting the Wires

Connect the electrical wires as follows:
- Connect the Black wire from the fixture to the black house (hot) Wire.
- Connect the white wire from the fixture to the white (neutral) house wire.
- Ensure all wire nuts are secured. You may wrap the connections with electrical tape.
- If your outlet box has ground wires (green or bare copper), connect the fixture’s ground wire to it. Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the fixture.

FAQ:

Q: What should I do if I encounter issues during installation?

A: If you encounter any issues during installation, please contact our customer service at info@aviancelighting.net for assistance.

Q: Can I use this fixture outdoors?

A: This fixture is designed for indoor use only and should not be used outdoors.

MOUNTING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to lose any small parts necessary for installation.
Attach the mounting plate to the junction box using two junction box screws as shown. The side of the mounting plate marked “GND” must face out. The junction box is not included.
Guide fixture wires through the hole in the center of the mounting plate.
Follow wiring instructions carefully (see fig.2).
Place the lamp body(A) over the mounting plate, aligning the backplane holes with the screw hole of the mounting plate on the side, then lock it securely with mounting screws.
Place the glass(B)/collaring ring(C)/check ring(D) insert into the lamp holder, lock them securely with the socket wrench(E), then remove the socket wrench and save it.
Install the light bulbs(not included) under the fixture’s specifications.

NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire.
- Connect the white wire from the fixture to the white (neutral) house wire.
- Make sure all wire nuts are secured. You may wrap the connections with electrical tape.
- If your outlet box has ground wires (green or bare copper) connect the fixture’s ground wire to it.
- Otherwise, attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING, IN