AViANCE Lighting HD82090 Ashford 1-Light Black Wall Sconce Installation Guide
- June 1, 2024
- AViANCE lighting
Table of Contents
ASSEMBLING & INST A LLA TION INSTRUCTIONS
HD82090 Ashford 1-Light Black Wall Sconce
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
HD82090
◆ WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Drilling two holes in the wall, distance and the same distance from the keyhole of mounting plate, then loaded plastic anchors. Attach the mounting plate to the wall, aligning the plastic anchors and junction box, lock it securely with the two wood screws and the two box screws. The side of the mounting plate marked “GND” must face out. The junction box is not included.
- Guide fixture wires through hole in center of mounting plate.
- Follow wiring instructions carefully (see fig.2).
- Place the fixture body (C) over the mounting plate, aligning the backplane holes with screw hole of the mounting plate in side, then lock it securely with mounting screws.
- Raise the glass shade(B) insert the lamp holder, lock it securely with the check ring(A).
- Install the light bulbs(Not included) in accordance with the fixture’s specifications.
NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:
info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED.
AVIANCE LIGHTING,INC.
DOC20240HD82090
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>