AVIANCE Lighting HD66977 23.5 Inch 3-Light Brushed Nickel Vanity Instruction Manual

Table of Contents

AVIANCE-Lighting-HD66977-23.5-Inch-3-Light-Brushed-Nickel-Vanity-
PRO

Specifications:

Assembling & Installation:

Shut off the power at the circuit breaker box and remove the old fixture and hardware from the Junction Box.
Unpack the new fixture and lay out all parts. Be careful not to lose any small parts needed for installation.
Drill two holes in the wall at a specific distance and load plastic anchors. Attach the mounting plate to the wall using wood screws and box screws.
Guide fixture wires through the center hole of the mounting plate.
Follow wiring instructions carefully, connecting black and white fixture wires to corresponding house wires.
Attach the fixture body over the mounting plate and secure it with mounting screws.
Install the glass shade over the lamp holder and secure it with a check ring.
Install light bulbs in accordance with the fixture’s specifications, ensuring not to exceed the maximum wattage rating.

Connecting the Wires:

Connect black fixture wire to black house wire, white fixture wire to white house wire, and ground wire accordingly.
If there is a ground wire in the outlet box, connect the fixture’s ground wire to it; otherwise, attach it to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.

Q: What should I do if I exceed the maximum wattage rating?
A: Do not exceed the maximum wattage rating specified for the fixture as it may cause damage or pose a safety hazard. Use bulbs within the recommended wattage range.
Q: How can I get assistance with parts or assembly?
A: For assistance with parts or assembly, please email customer service at info@aviancelighting.net.

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVIANCE-Lighting-HD66977-23.5-Inch-3-Light-Brushed-Nickel-
Vanity-1

Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
Drilling two holes in the wall, distance and the same distance from the keyhole of mounting plate, then loaded plastic anchors. Attach the mounting plate to the wall, aligning the plastic anchors and junction box, lock it securely with the two wood screws and the two box screws. The side of the mounting plate marked “GND” must face out. The junction box is not included.
Guide fixture wires through hole in center of mounting plate.
Follow wiring instructions carefully (see fig.2).
Place the fixture body (C) over the mounting plate, aligning the backplane holes with screw hole of the mounting plate in side, then lock it securely with mounting screws.
Raise the glass shade(B) insert the lamp holder, lock it securely with the check ring(A).
Install the light bulbs(Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

AVIANCE-Lighting-HD66977-23.5-Inch-3-Light-Brushed-Nickel-
Vanity-2

Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test the fixture.

Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at: info@aviancelighting.net