AVIANCE Lighting 1076 Ring Lock Glass Fixture Instruction Manual
- May 15, 2024
- AViANCE lighting
Table of Contents
**AVIANCE Lighting 1076 Ring Lock Glass Fixture Instruction Manual
**
ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Drilling two holes in the wall, distance and the same distance from the keyhole of mounting plate, then loaded plastic anchors(A). Mount the back plate(B) to the wall with the plastic anchors(A), the wood screw (D) and the two box screw (E). The side of the back plate marked “GND” must face out. The junction box is not included.
- Guide fixture wires through hole in center of back plate.
- Follow wiring instructions carefully. (see fig.2)
- Place the lamp body(F) onto the back plate so that the back plate studs protrude through the cover plate holes and lock it securely with the ball nut(J).
- Raise the glass shade(H) to bottom of the lamp holder(G), and using the check ring(I) by turning it clockwise until tight.
- Install the light bulbs(Not included) in accordance with the fixture’s specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete Return power to the junction box and test the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service
at:info@aviancelighting.net
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>