Delta Dore DU Tyxal Universal Radio Installation Guide

June 15, 2024
DELTA DORE

Delta Dore logo DU Tyxal Universal Radio
Installation Guide
DU TYXAL +
www.deltadore.com

DU Tyxal Universal Radio

Delta Dore DU Tyxal Universal Radio
Delta Dore DU Tyxal Universal Radio - fig2

| LS 14250 – 3,6 V – 1,2 Ah – Lithium
---|---
|
| Consumption stand-by : 3,5 pA
Consumption : 14,2 mA max.
| X3D alarme : [868 – 868.6] MHz et [868.7 – 869.2] MHz 100 m , 300m Maximum radio power < 10 mW, receiver category: 2
| -10°C / +70°C
| +5°C / +40°C
IP| IP 30 – IK 02
| 75%
| 33x 102 x 32 mm59 gr.
Environmental class I
Tam-per alarm on opening or removal of unit.
Important product information (0 0)

***** Up to 10 years valid under the conditions of use specifi ed in the installation instructions and the General Conditions of Sale

Contents

Delta Dore DU Tyxal Universal Radio - Contents

Presentation

The detector must be associated with a DELTA DORE wireless X3D alarm system.

Location

  •  The universal detector operates with a hard-wired sensor. Install the transmitter close to the sensor (cable length must not exceed 2 m).
  • The universal detector must be installed indoors.
  • Refer to the guide for the location and mounting of the sensor.

Fixation

Delta Dore DU Tyxal Universal Radio - Fixation

  1. Open the unit.
  2. Mark and drill holes D1 and D2.
  3. Attach the transmitter base with the V1 and V2 screws.

Activation

Delta Dore DU Tyxal Universal Radio - Activation

  1. Intruder: connect the intruder alarm wires to the AL and Com terminals, and the tamper alarm wires to the AP and Com terminals.
    Other: connect the 2 wires of a sensor of your choice to the universal detector AL and Com terminals.
    The AP terminal is not connected.

  2. Insert the battery and close the unit.

Switches

Switches SWA and SWB are used to configure the product.

| SWA 1 = ON
Technischer Alarm| SWA 1 = OFF
Intruder detection
---|---|---
__

__

__

SWA 2

| ON| OFF| ON| OFF
Normally closed|  Normally open|  Normally closed| Normally open
__

__

__

SWB

1

| | ON| OFF
 Tamper alarm inactive|  Tamper alarm active
__

__

__

SWB 2

| | ON| OFF
Delayed|  Immediate

If your alarm system has a CLT 8000 touch sensitive keypad, switch SWB2 will be ignored as this configuration is done on the keypad.

Operation with an alarm system

  • Association with an alarm system
  • Selection of triggering mode
  • Test
  • Restoring factory settings

Refer to system installation guide

Changing the batteries

Delta Dore DU Tyxal Universal Radio - Changing the
batteries

Low batteries are indicated on the installation’s CLT 8000 touchscreen keypad.
Before opening the unit, the alarm control unit must be in Maintenance mode (refer to system installation guide).
Once the low battery has been removed, wait a minute prior to inserting the new battery.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals