DELTA DORE Tydom Home Smart Home Hub User Manual
- June 12, 2024
- DELTA DORE
Table of Contents
Tydom Home Smart Home Hub
User Manual
Tydom Home Smart Home Hub
INFO APPLICATION
The connection quality of the product may be affected by different modifications
of the IP architecture on which it operates.
These modifications can be, but are not limited to, a change of hardware, a
software update or configuration, work conducted on your operator’s equipment
or any other multimedia equipment such as tablets, smartphones, etc.
IOS is a Cisco trademark or registered trademark in the United States and in
other countries, and is used under licence. Android™ and Google Play are
Google LLC registered trademarks.
Wi-Fi™ is a trademark registered by Wi-Fi Alliance. Because of changes in
standards and equipment, the characteristics given in the text and the
illustrations in this document are not binding unless confirmed.
Presentation
Box contents
A. Tydom Home
B. Ethernet cable
C. Mains supply
D. Important Product Information
Description
E. System status display LED
F. Ethernet port
G. Mains power socket
H: Configuration/Information button
Installation
-
Connect your Tydom Home by STRICTLY following this order:
① connect the Ethernet cable (B).
② then, connect the mains power (C). -
Download the Tydom app.
– Log in to either the Google Play or App Store, depending on your device.
– Search for and download the free Tydom app.|
---|---
http://opn.to/a/FCF9K| http://opn.to/a/JPzL4 -
Activate the Wi-Fi connection on your smartphone or tablet, and connect to the same local network as your Tydom Home.
-
Configure the Tydom app.
– Note the last 6 characters of your Tydom Home’s MAC address.
– Log in to the app and follow the instructions.
Technical specifications
| Power supply via AC adapter
Ktec: KSAS0050500100VED or SPC: ZZU1001-10050-2E
AC values: 100-240V~ 50/60 Hz, 0,18A – DC: 5V 1A
Only these adapters should be used with the Tydom Home.
---|---
| X3D transmission frequency: 868.7 MHz to 879.2 MHz
Maximum wireless power < 10mW – Category 2 receiver
Zigbee transmission frequency: 2.4 GHz to 2.4835 GHz
/ON| Maximum consumption (without USB connection): 0.9 W
| -20°C / +70°C
| -10°C / +40°C
IP| IP 30
| 100 x 100 x 26 mm
Help
| LED | System status |
|---|---|
| Flashing white | System accessible locally and remotely, user connected |
| Steady white | System accessible locally and remotely |
| Flashing orange | System accessible locally, user connected |
| Steady Orange | System accessible locally |
| Steady Red | No IP address allocated |
Advanced functions
Below are the functions accessible depending on how long the button on the
back of your Tydom Home is pressed.
A Secure connection and viewing connection status
Briefly press the button. LED displays for 10 seconds.
| Flashing yellow | Static IP mode |
|---|---|
| Flashing blue | DHCP mode |
| Flashing blue (3x) | DHCP in progress Check the DHCP activation on the router |
| Flashing red | No network connection Check the Ethernet link |
B Change from static IP to DHCP
Press the button for 3 seconds until the pink LED flashes slowly. Release.
C Reset to factory settings
Press the button for 30 seconds until the LED stops flashing. Release.
System status| – DHCP mode
– Clear product associations
---|---