Brodit IP1200 Qi Wireless Charging Holder User Manual

Brodit IP1200 Qi Wireless Charging Holder

SPECIFICATIONS

Wireless Output: 5W / 7.5W / 10W
Input: DC 5V / 9V
Ports: 1 x Type-C USB
Size: 127mm x 88mm x 50mm

PRODUCT LAYOUT

1.  Type-C USB port
2.  LED Indicator
3.  Tilt Swivel
4.  Amps Standard Mounting Plate

CONNECT YOUR HOLDER

1.  Connect the Type-C USB cable to the holder and either the cigarette charger or install kit included.
2.  The LED indicator will flash red once then remain off while in standby mode.
3.  The holder is now ready to start charging your phone.

CHARGE YOUR DEVICE

1.  Carefully slide your phone down the holder groves until it naturally rests at the bottom.
2.  The wireless charger will automatically connect to your phone and start charging.
3.  The holder LED indicator will turn blue when charging commences and your phone screen will display the charging icon.

REMOVE YOUR DEVICE

1.  Your phone can be removed anytime while charging. Carefully slide your phone up the holder groves until fully removed.
2.  The holder stops charging automatically when your phone is removed.
3.  The holder LED indicator will turn off when in standby mode.

LED STATUS

Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Statment

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE:
This device complies with part 18 of the FCC Rules. Information to the user.

1.  The device has potential interference, but the interference is very small and meets the requirements of the FCC rule
2.  Equipment system maintenance is simple, please refer to the manual
3.  The user can take simple measures to correct the interference. Such as staying away from interference sources, turning off interference sources, etc.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>