BRExhaust 106-0375 Jeep Direct Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
**BRExhaust 106-0375 Jeep Direct Fit Replacement Exhaust System Instruction Manual
**
INSTALLATION INSTRUCTION
**BILL OF MATERIALS:
- 168079
- 168350
- 167502
- 168349
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Begin installation by installing items 1 and 2 to existing exhaust
STEP 3:
Attach item 4 to existing isolators (cut inlet to fit)
STEP 4:
Connect item 4 and 2 together with item 3
STEP 5:
Attach clamp provided with item 4 to slip fit joint
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 7:
Tighten all clamps and bolts starting from rear of the vehicle. (DO NOT EXCEED
30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN
IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed
RExhaust recommends
professional installation for all products
CUT TO FIT INSTALLATION INSTRUCTIONS
DESIGN TABLE
DESIGN STYLE 1: CUT TO FIT INTERMEDIATE PIPE
MATCH PURCHASED KIT’S CUT TO FIT DESIGN
TO GRAPHIC IN DESIGN TABLE
DESIGN STYLE 1
STEP 1:
Attach item 1 to existing exhaust
STEP 2:
Attach item 3 to existing isolators
STEP 3:
Cut item 2 4” longer than the distance between the installed parts,this will
allow for a 2” overlap for each slip fit (cutting part too short will increase
likelihood of leaks)
**DESIGN STYLE 2: CUT TO FIT INLET
DESIGN STYLE 2
STEP 1:**
Attach item 3 to existing isolators
STEP 2:
Attach item 2 to item 3
STEP 3:
Cut item 2 2” longer than the distance between item 2 and OEM part, this will
allow for a 2” overlap (cutting part too short will increase likelihood of
leaks
**DESIGN STYLE 3: CUT TO FIT TAIL PIPE
DESIGN STYLE 3
STEP 1:
Attach item 1 to existing isolators
STEP 2:**
Attach item 3 to existing isolators
WARNING
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>