BRExhaust 106-0451 Kits Exhaust Pipe Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0451 Kits Exhaust Pipe
INSTALLATION INSTRUCTIONS
- PART NO. 106-0451
BILL OF MATERIALS
- 167538
- 169491
- 171602
- 172118
- 171592
- 171595
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 2 to existing isolator and exhaust with item 1
- For 120.5” WB do not use item 1& 2
- For 140” WB use x1 of item 1 & 2
- For 160” WB use x2 of item 1 & 2
STEP 3:
Connect item 4 to existing isolator and item 2 (OE system for 120.5” WB) with
item 3
STEP 4:
Connect item 5 to existing isolator and item 4 with item 1
STEP 5:
Connect item 6 to existing isolator and item 5 with item 1
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 7:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please
allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
- BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271 BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>