BRExhaust 107-0067 Direct Fit Front Pipe Kit Instructions
- May 15, 2024
- BRExhaust
Table of Contents
INSTALLATION INSTRUCTIONS
PART NO. 107-0067
107-0067 Direct Fit Front Pipe Kit
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing front pipe from the vehicle. Only remove parts that will be replaced.
Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach [3] Front Pipe Assembly to existing exhaust with supplied inlet [2]
Hardware and [1] Gasket and supplied outlet [5] Hardware and [4] Gasket.
STEP 3:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate
Ctr, Oceanside, CA 92056
www.brexhaust.com
REV #000 DATE 7/7/2023
Documents / Resources
|
BRExhaust 107-0067 Direct Fit Front Pipe
Kit
[pdf] Instructions
107-0067 Direct Fit Front Pipe Kit, 107-0067, Direct Fit Front Pipe Kit, Fit
Front Pipe Kit, Front Pipe Kit, Pipe Kit, Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>