BRExhaust 167669 Stock Replacement Exhaust Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
INSTALLATION INSTRUCTIONS
PART NO. 106-0523
167669 Stock Replacement Exhaust
BILL OF MATERIALS:
- 167669
- 168438
- 168030
- 167503
- 168765
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before removal of the OEM exhaust system. This will prevent electrical
accidents and will reset the computer if it applies to the vehicle. Remove
existing exhaust system from the vehicle. Only remove parts that will be
replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 2 (cut intermediate pipe to fit) to existing isolators and exhaust
with item 1 (nuts and bolts not included)
STEP 3:
Attach item 5 to existing isolators and item 2 with item 4
STEP 4:
Using item 3 reconnect sensor (nuts not included)
STEP 5:
Connect slip fit for items 5 with clamps provided
STEP 6:
Ensure new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 7:
Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB
WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
CUT TO FIT INSTALLATION INSTRUCTIONS
DESIGN TABLE
DESIGN STYLE 1: CUT TO FIT INTERMEDIATE PIPE
DESIGN STYLE 2: CUT TO FIT INLET
DESIGN STYLE 3: CUT TO FIT TAIL PIPE
MATCH PURCHASED KIT’S CUT TO FIT DESIGN
TO GRAPHIC IN DESIGN TABLE
DESIGN STYLE 1
STEP 1:
Attach item 1 to existing exhaust
STEP 2:
Attach item 3 to existing isolators
STEP 3:
Cut item 2 4” longer than the distance between the installed parts, this will
allow for a 2” overlap for each slip fit (cutting part too short will increase
likelihood of leaks)
DESIGN STYLE 2
STEP 1:
Attach item 3 to existing isolators
STEP 2:
Attach item 2 to item 3
STEP 3:
Cut item 2 2” longer than the distance between item 2 and OEM part, this will
allow for a 2” overlap (cutting part too short will increase likelihood of
leaks)
DESIGN STYLE 3
STEP 1:
Attach item 1 to existing isolators
STEP 2:
Attach item 3 to existing isolators
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injuryor death
could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>