BRExhaust 106-0126 Kits Muffler Instruction Manual

BRExhaust 106-0126 Kits Muffler

Product Information

• Product Name: OEM Exhaust System
• Part Number: 106-0126
• Manufacturer: BRExhaust
• Manufacturer Address: 1901 Corporate Ctr, Oceanside, CA 92056
• Manufacturer Website: www.brexhaust.com.
• Technical Support: 1-800-631-7271

Product Usage Instructions

1. Step 1: Disconnect the vehicle’s battery before removal of the OEM exhaust system. This is important to prevent electrical accidents and reset the computer if applicable to the vehicle. Remove the existing exhaust system from the vehicle, only removing the parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
2. Step 2: Attach item 2 to the existing exhaust and isolators using items 1 and 5.
3. Step 3: Attach item 4 to the existing isolators and item 2 using item 3.
4. Step 4: Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
5. Step 5: Tighten all clamps, starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening the clamp. After driving for 50 miles, check all clamps and retighten if necessary.

Warning: When working on, under, or around any vehicle, exercise caution. Allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed. BRExhaust recommends professional installation for all products.

BILL OF MATERIALS

1. 169305
2. 167780
3. 167503
4. 167781
5. 169481

INSTALLATION STEPS

• STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
• STEP 2: Attach item 2 to existing exhaust and isolators with items 1 and 5
• STEP 3: Attach item 4 to existing isolators and item 2 to item 3
• STEP 4: Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
• STEP 5: Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

WARNING:

• When working on, under, or around any vehicle exercise caution.
• Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns.
• If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

BRExhaust recommends professional installation for all products

• Technical Support: 1-800-631-7271
• BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
• www.brexhaust.com.

References

• MagnaFlow Exhaust, Mufflers & Cat Converters - Quality. Power. Sound.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>