BRExhaust 106-0686 Kits Exhaust Pipe Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0686 Kits Exhaust Pipe
Product Information
The product is an exhaust system manufactured by BRExhaust. The part number for this specific product is 106-0686. The package includes the following components:
BRExhaust recommends professional installation for all their products. For technical support, you can contact them at 1-800-631-7271. The company’s address is 1901 Corporate Ctr, Oceanside, CA 92056. You can also visit their website at www.brexhaust.com.
Product Usage Instructions
Please carefully read all the instructions before proceeding with the installation. It is important to disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the computer if applicable to the vehicle.
It is important to exercise caution when working on, under, or around any vehicle. Allow the vehicle’s exhaust system to cool before removal to avoid burns from the hot exhaust temperatures. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area to prevent serious injury or death.
INSTALLATION INSTRUCTIONS
BILL OF MATERIALS
WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s
battery before the removal of the OEM exhaust system. This will prevent
electrical accidents and will reset the computer if it applies to the vehicle.
Remove the existing exhaust system from the vehicle. Only remove parts that
will be replaced. Clean the existing flange with a wire brush to ensure proper
sealing.
STEP 2:
Attach item 1/2 (cut item 1 to match OE) to the existing exhaust with item 1
(nuts and bolts not included)
STEP 3:
Attach item 4 to the existing isolator and item 2 with items 3 and 6 (nuts and
bolts not included)
STEP 4:
Attach item 5 to item 4 with item 3
STEP 5:
Ensure the new exhaust is not contacting any portion of the underbody of the
vehicle or drivetrain.
STEP 6:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-
LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF
NECESSARY)
BRExhaust recommends professional installation for all products
Technical Support: 1 -800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>