BRExhaust 108-0086 Direct Fit Muffler Kit Instruction Manual
- May 15, 2024
- BRExhaust
Table of Contents
BRExhaust 108-0086 Direct Fit Muffler Kit
PRODUCT OVERVIEW
BRExhaust recommends professional installation for all products
SAFETY
WARNING:
When working on, under, or around any vehicle exercise caution.
Please allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications.
Always wear safety glasses and ensure a safe work area. Serious injury or
death could occur if safety measures are not followed.
INSTALLATION INSTRUCTIONS
STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach [3] Muffler Assembly to existing exhaust and isolators with supplied [1] Gasket and [2] Hardware.
STEP 3: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 4: Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
Technical Support
1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>