BRExhaust 106-0360 Kits Exhaust Pipe Instruction Manual

: June 13, 2024
: BRExhaust

Table of Contents

BRExhaust 106-0360 Kits Exhaust Pipe
Product Information
Product Usage Instructions
INSTALLATION INSTRUCTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BRExhaust 106-0360 Kits Exhaust Pipe

Product Information

Product Name: Exhaust System

Model Number: 106-0360

Manufacturer: BRExhaust

Website: www.brexhaust.com

Technical Support: 1-800-631-7271

Address: 1901 Corporate Ctr, Oceanside, CA 92056

Product Usage Instructions

Disconnect the vehicle’s battery before removing the OEM exhaust system to prevent electrical accidents and reset the vehicle’s computer.
Remove the existing exhaust system, only removing parts that will be replaced.
Clean the existing flange with a wire brush to ensure proper sealing.
Attach item 2 to the existing exhaust/vehicle mount using item 1 (nuts and bolts not included).
Attach item 3 to item 2 using item 1 (nuts and bolts not included).
Connect the slip-fit joints on items 3 and 2 using the provided clamps.
Ensure that the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
Tighten all clamps starting from the rear of the vehicle. Do not exceed 30 ft-lb when tightening the clamps. Check all clamps after driving for 50 miles and retighten if necessary.

Warning:

When working on, under, or around any vehicle, exercise caution. Allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

Note:

BRExhaust recommends professional installation for all products.

INSTALLATION INSTRUCTIONS

PART NO. 106-0360

BILL OF MATERIALS:

WARNING:

When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.

STEP 2:
Attach item 2 to the existing exhaust/vehicle mount with item 1 (nuts and bolts not included)

STEP 3:
Attach item 3 to item 2 with item 1 (nuts and bolts not included)

STEP 4:
Connect slip-fit joints on items 3 and 2 with clamps provided

STEP 5:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.

STEP 6:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT- LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

BRExhaust recommends professional installation for all products