BRExhaust 106-0674 Direct Fit Exhaust System Instruction Manual

: June 13, 2024
: BRExhaust

Table of Contents

BRExhaust 106-0674 Direct Fit Exhaust System
Product Information
Product Usage Instructions
INSTALLATION INSTRUCTIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BRExhaustLOGO

BRExhaust 106-0674 Direct Fit Exhaust System

Product Information

Product Name: Exhaust System
Part Number: 1 06-0674
Manufacturer: BRExhaust

Product Usage Instructions

Step 1: Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
Step 2: Attach item 2/6 (match OE) to the existing exhaust with item 1 (nuts and bolts not included).
Step 3: Connect item 4 to the existing isolator and item 2/6 with items 3 and 7 (nuts and bolts not included).
Step 4: Connect item 5 to the existing isolator with item 4 with item 3.
Step 5: Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
Step 6: Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

BRExhaust recommends professional installation for all products.

Technical Support: 1-800-631-7271
BRExhaust Address: 1901 Corporate Ctr, Oceanside, CA 92056
Website: www.brexhaust.com

INSTALLATION INSTRUCTIONS

BILL OF MATERIALS

WARNING: When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult the vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.

STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
STEP 2:
Attach item 2/6 (match OE) to existing exhaust with item 1 (nuts and bolts not included)
STEP 3:
Connect item 4 to the existing isolator and item 2/6 with items 3 and 7 (nuts and bolts not included)
STEP 4:
Connect item 5 to the existing isolator with item 4 with item 3
STEP 5:
Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 6:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT- LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)