BRExhaust 108-0055 Direct Fit Muffler Kit Instruction Manual
- June 1, 2024
- BRExhaust
Table of Contents
INSTALLATION INSTRUCTIONS | PART NO. 108-0055
STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach [3] Muffler Assembly to existing exhaust and isolators with supplied [1] Gasket and [2] Hardware.
STEP 3: Ensure new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
STEP 4: Tighten all clamps starting from rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns. If working without a lift, always consult vehicle manual for correct lifting specifications. Always wear safety glasses and ensure a safe work area. Serious injury or death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
REV 000 DATE 8/4/2023