n-FAB HPD2080CC Podium Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
HPD2080CC Podium Hoop Step
Do not use
impact toolsn-FAB.com
I-SHEET PART NUMBER: INST-00251
PART NUMBER: HPD2080CC, HPD2086MC
HPD15103CC-6
PRODUCT: PODIUM HOOP STEP
APPLICATION: 19-22 RAM 2500/3500 CC, MC
15-18 1500 CC
| HARDWARE DESCRIPTION | QTY. |
|---|---|
| 10 mm zinc u-nut | 6 |
| 10mm zinc bolt | 6 |
| 8mm zinc lock washer | 6 |
| 8mm zinc washer | 12 |
| 8mm black bolt | 6 |
| 10mm black washer | 6 |
| 8mm black ny-lock nut | 6 |
| M10X25mm Carriage bolt | 12 |
| M10 hex nut | 12 |
| PARTS INCLUDED | QTY |
| --- | --- |
| Driver side step | 1 |
| Passenger side step | 1 |
| Mounting bracket | 12 |
Step 1 : Identify driver side step. 
Step 2. Install the (x6) mounting brackets to each attachment point on the
main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave
loose for now.
** NOTE: The brackets will attach to the backside of the mounting flange
with the threaded end of the carriage bolt facing towards the REAR of the
step. *
NOTE:
The bends on the driver andpassenger front bracket will point forward when
mounted to vehicle.
Step 3: Remove any factory running boards or steps and discard.
Step 4: Next, locate the mounting holes underneath the body and remove
the factory tape from the three locations.
Step 5 : Insert the supplied threaded U-
clips in each mounting location.
U-clip positioning. NOTE: Clip orientation will be the
same for passenger side.
Step 6: If installing the bed access step prt# D20100CC-6, you have the
option of removing the plastic bed molding. If so, proceed before moving to
step 6. 
Step
7: Carefully place step into position and start the upper 3/8”X1” hex bolt
and 3/8” flat washer in the center bracket and hand tighten to hold in place.
Next, install the remainder 3/8”x1” hex bolts and 3/8” washer in the front and
rear brackets and leave loose for now.
Step 8: Insert the black zinc M8 flanged bolts and
flanged nuts in the pinch weld holes and leave loose for now.
Step 9: Begin tightening the
lower attachment points starting with the rear bracket working your way up to
the front bracket. ( 20ft/lbs )
Step 10: Tighten the upper attachments points from front to back. (
20ft/lbs )
Step 11. After finial adjustment, tighten all three brackets at the main
tube.
Step
12: Repeat steps 2-11 for passenger side. Your install is now complete.
12302 Shiloh Church Rd. Houston TX 77066
Phone281-880-6322
Fax281-880-6325
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>