n-FAB 705418012 Hoop Step Instruction Manual

June 13, 2024
n-FAB

I-SHEET NUMBER: INST-00283
PART NUMBER: 705418012
PRODUCT: HOOP STEP
APPLICATION: TOYOTA TACOMA CC

705418012 Hoop Step

HARDWARE DESCRIPTION QTY.

HWKT-03054X
| 10MM Carriage bolt| 12
| 10MM flanged nut| 12
FLBW00894X| M8-1.25 X 30MM CLASS 8.8
FLANGE CAP SCREW W/WASHER| 12
PARTS INCLUDED| QTY
---|---
DRIVER SIDE| 1
PASSENGER SIDE| 1
MOUNTING BRACKETS| 1

Step 1 : Identify Driver side step

Step 2. Install the (x6) mounting brackets to each attachment point on the main tube using the supplied M10x25 carriage bolts, M10 hex nuts and leave loose for now. Note the bracket orientation for driver and passenger.

Step 2 Remove any factory hardware and discard.

Step 3: Position step up to the body of the vehicle and align the brackets up with the factory mounting locations.
Step 4: Beginning with the center bracket, start one of the M8x30mm hex bolts into the factory bolt location and leave loose. Start the second M8x30mm hex bolt in the same bracket and loosely tighten.
Step 5: Start all remaining M8x30mm hex bolts in each bracket and leave loose.
Step 6: After final positioning, start at the rear of the vehicle and tighten the lower fastener to 1520 ft/lbs of torque. Continue this until all of the lower fasteners have been tightened, then move to the top bolt and repeat the process.
Step 7: Next, tighten brackets (x3) at the main tube.
Step 8: Repeat steps 2-7 for passenger side.

nfabinc
n-fab.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals