n-FAB TSJ074-TX TrailSlider Step System Fits Instruction Manual

June 13, 2024
n-FAB

n-FAB-logo

n-FAB TSJ074-TX TrailSlider Step System Fits

n-FAB TSJ074-TX TrailSlider Step System Fits-product

Product Information

The product is a Trail Slider designed for Jeep JK 4DR vehicles manufactured between 2007 and 2017. Its part number is TSJ074-TX and the installation instructions can be found in the INST-02319 manual. The necessary components and hardware for installation are included in the HWKT-13100X kit.

Instruction

Components and Hardware: HWKT-13100X

n-FAB TSJ074-TX TrailSlider Step System Fits-01

Components and Hardware

  1.  Driver side slider………………………………………………………………..(1)
  2. Passenger side slider…………………………………………………………(1)
  3. M8X25mm flanged hex bolt………………………………………………..(18)
  4. M8 flanged hex nut……………………………………………………………(12)
  5. 3/8”x 3/4” nut clip……………………………………………………………..(6)
  6. 3/8”x1” flanged hex bolt…………………………………………………….(6)

These warranties do not cover any damage, defect, or malfunction caused by misuse, abuse, accident, improper installation, modification, improper or inadequate maintenance, or on-road and off-road hazards. Incidental and consequential damages are not recoverable under this warranty. Some states or providence do not allow the exclusion or limitation of incidental or consequential damages, so this exclusion or limitation may not apply to you.

Tools for Installation

  •  1133mm smm soocckkeett
  • 1133mm reenncchh
  •  33//88”” s soockckeett
  • RRaattchcheett wrreennchch

INSTALL

Step 1.
Remove any factory running boards or steps and dis- card.

n-FAB TSJ074-TX TrailSlider Step System Fits-02

Step 2.
Locate the (x3) factory mounting location on the pinch weld. Each location will have (x2) 3/8″ holes. Step 3. Depending on the year of your vehicle, you may need to open up the holes using a 3/8″ drill bit. Complete this step at this time. n-FAB TSJ074-TX TrailSlider Step System
Fits-03

Step 4.
Locate the (x3) mounting locations on the under- neath of the floor pan. Depending on the year, you may have M8 threaded holes or slots for U-clips. Step 5. If the (#5) 3/8″ U-clips are needed, install at this time. n-FAB
TSJ074-TX TrailSlider Step System Fits-04

Step 6.
Carefully raise #1) driver side trail slider up to the body, aligning brackets to the back side of the pinch weld mounting locations and loosely fasten the upper mounts using the (#3) M8 flanged hex bolts or (#6) 3/8″x1″ flanged hex bolts. Step 7. Install (#3)x6 M8×25mm hex bolts and (#4)x3 flanged hex nuts in the pinch weld mounts and leave loose for now. n-FAB TSJ074-TX TrailSlider
Step System Fits-05

Step 8.
After finial adjustment, tighten the (x3) upper mounts. Step 9. Next, tighten (x6) pinch weld mounts. Step 10. Repeat mounting procedure with (#2) passenger side Trail Slider.

n-FAB TSJ074-TX TrailSlider Step System Fits-06

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals