BRExhaust 106-0147 Muffler Kit Installation Guide
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0147 Muffler Kit
INSTALLATION INSTRUCTIONS
- STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing.
- STEP 2: Begin installation by installing items 1 and 2 to the existing exhaust
- STEP 3: Attach clamps provided with the kit on each of the slip-fit joints
- STEP 4: Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain.
- STEP 5: Tighten all clamps and bolts starting from the rear of the vehicle. (DO NOT EXCEED 30FT-LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
WARNING
When working on, under, or around any vehicle exercise caution. Please
allow the vehicle’s exhaust system to cool before removal, as exhaust
temperatures may cause severe burns. If working without a lift, always consult
vehicle manual for correct lifting specifications. Always wear safety glasses
and ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
- BRExhaust recommends professional installation for all products
- Technical Support: 1-800-631-7271
- www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>