BRExhaust 106-0296 Nissan Direct Fit Replacement Exhaust System Installation Guide
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0296 Nissan Direct Fit Replacement Exhaust System
Product Information
- Product Name: OEM Exhaust System
- Part Number: 106-0296
- Manufacturer: BRExhaust
Safety Instructions
- When working on, under, or around any vehicle, exercise caution.
- Allow the vehicle’s exhaust system to cool before removal, as exhaust temperatures may cause severe burns.
- If working without a lift, always consult the vehicle manual for correct lifting specifications.
- Always wear safety glasses and ensure a safe work area.
- Serious injury or death could occur if safety measures are not followed.
BRExhaust recommends professional installation for all products.
Technical Support
- Contact: 1-800-631-7271
Manufacturer Information
- BRExhaust 1901 Corporate Ctr, Oceanside, CA 92056
- Website: www.brexhaust.com.
INSTALLATION INSTRUCTIONS
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult the vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
INSTALLATION INSTRUCTIONS
-
STEP 1:
(Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove the existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean the existing flange with a wire brush to ensure proper sealing. -
STEP 2:
Attach item 7 to existing isolators -
STEP 3:
Connect item 6 to existing exhaust with item 1 and item 2 -
STEP 4:
Connect item 3 and 5 using item 4, then connect to existing exhaust using item 1 and item 2 -
STEP 5:
Connect item 5 and item 6 to item 7 using item 5 -
STEP 6:
Connect item 10 to existing isolators and connect item 9 using item 8 -
STEP 7:
Connect item 7 to item 9 using item 8 -
STEP 8:
Ensure the new exhaust is not contacting any portion of the underbody of the vehicle or drivetrain. -
STEP 9:
Tighten all clamps starting from the rear of the vehicle. (DO NOT EXCEED 30FT- LB WHEN TIGHTENING THE CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY).
BRExhaust recommends professional installation for all products.
Contact Information
- Technical Support: 1-800-631-7271
- BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056.
- www.brexhaust.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>