n-FAB HPJ0764 Hoop Step Instruction Manual
- June 13, 2024
- n-FAB
Table of Contents
n-FAB HPJ0764 Hoop Step Instruction Manual
Product Parts
SHEET NUMBER: INST-00265
PART NUMBER : HPJ0764
PRODUCT: HOOP STEP
APPLICATION : 2007-17 JEEP JK 4DR
| PARTS INCLUDED | QTY |
|---|---|
| DRIVER SIDE | 1 |
| PASSENGER SIDE | 1 |
| HARDWARE DESCRIPTION | QTY. |
| --- | --- |
HWKT-00848X
CLIP-00645X| 3/8”-16 X 9/16” BARRELNUT| 6
FDRW- 00736X| M8 FENDER WASHER| 6
FDRW- 03082X| M6 FENDER WASHER| 24
FLTW-00663X| 3/8” USS FLAT WASHER| 6
H HCS –00649X| M8-1.25 X 35MM CLASS 8.8 HEXCAP SCREW| 6
H HCS-00685X| 3/8”-16 X 1-1/2” GRADE 5HEX CA[ SCREW| 6
H HCS- 03080X| M6-1.00 X XXMM CLASS 8.8 HEX CAP SCREW| 12
HXNT- 03083X| M6-1.00 CLASS B FINISHED HEX NUT| 12
| M10X25mm Carriage bolt| 12
| M10 hex nut| 12
Step 1: Locate the driver side step rail.
Step 2 Install the (x6) mounting brackets to each attachment point on the
main tube and
leave loose for now.
NOTE: The brackets will attach to the backside of the mounting flange with the threaded end of the carriage bolt facing towards the REAR of the step.
-
PASSENGER
-
DRIVER
Step 3: Depending on your cab model, you will have to identify which hardware you will have to use for the upper (3) mounts on the underside of the body. There will either be existing 8mm threaded holes for the M8 x 20mm hex head bolts or open slots for the 3/8” speed clips and 3/8”x 1 ¼” Hex bolts
-
8mm Threaded hole
-
Slot with 3/8” Speed Clip
Step.4 Carefully raise step rail up to the pinch weld of the body and
align brackets up with the factory mounting locations.
Step. 5 Depending on your hardware selection made in step 2, fasten the
upper mounts and leave loose at this time.
Step. 6 Next, start all (x6) ¼-20”x 3/4” hex bolts, (x12) M8 flat
washers, (x6) 5/16” lock washers and (6) ¼”-20 HC Nut in the pinch weld
mounting locations and leave loose for now.
Step. 7: After finial positioning, completely tighten all (x6) ¼”-20 x ¾”
in the pinch weld attachment.
Step. 8: Next, tighten all (x3) upper body mount positions to 17-20
Ft/lbs. torque.
Step. 9: Repeat steps 2-5 for passenger side.
